Works matching IS 25882937 AND DT 2025 AND VI 9 AND IP 1
Results: 6
Influence of infill settings on the flexural properties of 3D printed ABS plus polymer parts in bending loading.
- Published in:
- AUT Journal of Mechanical Engineering, 2025, v. 9, n. 1, p. 83, doi. 10.22060/ajme.2025.23310.6121
- By:
- Publication type:
- Article
Solidification enhancement of phase change material in a triplex tube latent heat energy storage unit using longitudinal-parabolic fins.
- Published in:
- AUT Journal of Mechanical Engineering, 2025, v. 9, n. 1, p. 65, doi. 10.22060/ajme.2024.23620.6146
- By:
- Publication type:
- Article
Flexoelectric Cantilever Beam Mass Sensors: A Theoretical Investigation.
- Published in:
- AUT Journal of Mechanical Engineering, 2025, v. 9, n. 1, p. 53, doi. 10.22060/ajme.2024.23410.6130
- By:
- Publication type:
- Article
Mixed Longitudinal - Lateral Stability Control of Electric Vehicle Based on Online Tire - Road Friction Coefficients Estimation.
- Published in:
- AUT Journal of Mechanical Engineering, 2025, v. 9, n. 1, p. 33, doi. 10.22060/ajme.2024.23354.6123
- By:
- Publication type:
- Article
Design of two layer clamped-clamped microsensor based on classical and non-classical theories.
- Published in:
- AUT Journal of Mechanical Engineering, 2025, v. 9, n. 1, p. 19, doi. 10.22060/ajme.2024.23062.6116
- By:
- Publication type:
- Article
Numerical investigation of the spiral solar air heater performance.
- Published in:
- AUT Journal of Mechanical Engineering, 2025, v. 9, n. 1, p. 3, doi. 10.22060/ajme.2024.23366.6125
- By:
- Publication type:
- Article