The comparative thermodynamic analysis of compressor's energetic performance.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 152, doi. 10.18280/mmep.060120
- By:
- Publication type:
- Article
Works matching IS 23690739 AND DT 2019 AND VI 6 AND IP 1
Results: 20
1
2
Analytical solution of sea water steady magneto-hydrodynamic equations subjected to stretching sheet under induced magnetic field and heat transfer.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 141, doi. 10.18280/mmep.060119
- By:
- Publication type:
- Article
3
Diagnosis of causes for high railway traffic based on Bayesian network.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 135, doi. 10.18280/mmep.060118
- By:
- Publication type:
- Article
4
How does aerodynamics influence physiological responses in middle-distance running drafting?
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 129, doi. 10.18280/mmep.060117
- By:
- Publication type:
- Article
5
Mathematical modeling applied to renewable fishery management.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 121, doi. 10.18280/mmep.060116
- By:
- Publication type:
- Article
6
Research on the first passage of double-layer micro-plate in the piezoelectric model.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 115, doi. 10.18280/mmep.060115
- By:
- Publication type:
- Article
7
A numerical investigation of natural convection heat transfer of copper-water nanofluids in a rectotrapezoidal enclosure heated uniformly from the bottom wall.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 105, doi. 10.18280/mmep.060114
- By:
- Publication type:
- Article
8
The efficiency of the CORDIC Operator in the MIMO MC-CDMA receiver.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 99, doi. 10.18280/mmep.060113
- By:
- Publication type:
- Article
9
Solar drying of drying agricultural product (Apricot).
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 92, doi. 10.18280/mmep.060112
- By:
- Publication type:
- Article
10
An indigenous tool (NoJavaCloud) to handle virtual nodes to simulate the cloud tasks.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 85, doi. 10.18280/mmep.060111
- By:
- Publication type:
- Article
11
Study of air flow around flat and arc-shaped baffles in shell-and-tube heat exchangers.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 77, doi. 10.18280/mmep.060110
- By:
- Publication type:
- Article
12
Experimental investigation on multi-cylinder SI engine fueled conventional gasoline, ethanol blends, and micro-emulsion as an alternative fuel.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 69, doi. 10.18280/mmep.060109
- By:
- Publication type:
- Article
13
Analysis of cylindrical shells by the Least Squares Method.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 61, doi. 10.18280/mmep.060108
- By:
- Publication type:
- Article
14
Numerical analysis of heat and nanofluid mass transfer in a channel with detached and attached baffle plates.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 52, doi. 10.18280/mmep.060107
- By:
- Publication type:
- Article
15
Investigation of energy saving in building by using phase-change materials (PCM).
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 47, doi. 10.18280/mmep.060106
- By:
- Publication type:
- Article
16
A computational analysis for boundary layer flow of magneto hydrodynamic tangent hyperbolic fluid of heat and mass transfer past a stretching cylinder with suction/injection using spectral relaxation method.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 38, doi. 10.18280/mmep.060105
- By:
- Publication type:
- Article
17
Makespan reduction using dynamic job sequencing combined with buffer optimization applying genetic algorithm in a manufacturing system.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 29, doi. 10.18280/mmep.060104
- By:
- Publication type:
- Article
18
Heat and nanofluid transfer in baffled channels of different outlet models.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 21, doi. 10.18280/mmep.060103
- By:
- Publication type:
- Article
19
The impacts of heat generation/absorption and partial slip on boundary layer flow and heat transfer of a nanofluid comprising of self-impelled motile microorganisms passing a stretching sheet.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 10, doi. 10.18280/mmep.060102
- By:
- Publication type:
- Article
20
Performance effects and economic viability of high-hydrated ethanol fumigation and diesel direct injection in a small compression ignition engine.
- Published in:
- Mathematical Modelling of Engineering Problems, 2019, v. 6, n. 1, p. 1, doi. 10.18280/mmep.060101
- By:
- Publication type:
- Article