Works matching IS 2251600X AND DT 2016 AND VI 35 AND IP 2
Results: 10
A Comparative Study of the Addition Effect of Diopside and Silica Sulfuric Acid Nanoparticles on Mechanical Properties of Glass Ionomer Cements.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 131, doi. 10.18869/acadpub.jame.35.2.131
- By:
- Publication type:
- Article
Investigating Formation of Intermetallics in Compound Casting of Al/Cu Bimetals.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 115, doi. 10.18869/acadpub.jame.35.2.115
- By:
- Publication type:
- Article
Evaluation of Properties of Crofer Stainless Steel Produced by Mechanical Alloying for Using as Interconnect Plates of Solid Oxide Fuel Cells.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 95, doi. 10.18869/acadpub.jame.35.2.95
- By:
- Publication type:
- Article
Effects of Melt/Solid Volume Ratio and Rotational Speed on the Interface of Al/Mg Bimetal in Centrifugal Casting.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 83, doi. 10.18869/acadpub.jame.35.2.83
- By:
- Publication type:
- Article
Effects of Nb on Increasing Glass Form Ability in Fe- based Amorphous Alloys of Fe<sub>55-x</sub>Cr<sub>18</sub>Mo<sub>7</sub>B<sub>16</sub>C<sub>4</sub>Nb<sub>x</sub> (X=0, 3, 4, 5).
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 67, doi. 10.18869/acadpub.jame.35.2.67
- By:
- Publication type:
- Article
Elimination of Mn<sub>3</sub>Ga with Low Crystal Symmetry in Alloying Mn-Ga by Ge Addition.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 55, doi. 10.18869/acadpub.jame.35.2.55
- By:
- Publication type:
- Article
Characterization of Al-CNT Composite Nanoparticles Synthesized by Electrical Explosion of Wire in Acetone.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 47, doi. 10.18869/acadpub.jame.35.2.47
- By:
- Publication type:
- Article
Effect of Structure and Surface Roughness on Wetting Angle of a Hypoeutectic Cast Iron.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 31, doi. 10.18869/acadpub.jame.35.2.31
- By:
- Publication type:
- Article
Evaluation and Comparison of the Effects of RRA, T73 and T6 Heat Treatments on Hardness, Tensile and Bending Strengths of 7075 Aluminum Alloy.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 11, doi. 10.18869/acadpub.jame.35.2.11
- By:
- Publication type:
- Article
Development of High Energy Thin Layers of Exchange Spring Magnets Originating from Rare Earth Magnets of NdFeB/FeCo.
- Published in:
- Advanced Materials in Engineering, 2016, v. 35, n. 2, p. 1, doi. 10.18869/acadpub.jame.35.2.1
- By:
- Publication type:
- Article