Works matching IS 19708734 AND DT 2011 AND VI 5 AND IP 4
Results: 30
Experimental Investigation on the Use of Flat Mini Heat Pipes for Avionics Electronic Modules Cooling.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 770
- By:
- Publication type:
- Article
Sensitivity Analysis of Air Mass Flow Rate through Underhood by Simulation of Flow from Front Intake to Undertray.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 717
- By:
- Publication type:
- Article
Bio-Fuel Atomizer Design for Micro-Gas Turbine.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 712
- By:
- Publication type:
- Article
Study of Air Flow in a Ventilated Local: Influence of Speed Blowing and Solar Flux on an Occupant's Thermal Comfort.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 706
- By:
- Publication type:
- Article
Development of Low Cost High Rise Building Using Austenitic-Ferritic Material in Nano-Scale Environmental Challenges to Sustain a Green Building.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 784
- By:
- Publication type:
- Article
The Concept and Application of Miniaturization Boiling in Reactor Cooling System.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 754
- By:
- Publication type:
- Article
Combination of Adaptive Methods for Turbulence Flows.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 760
- By:
- Publication type:
- Article
Numerical Model for a Hydraulic Ram Pump.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 733
- By:
- Publication type:
- Article
Numerical Analysis of Laminar Boundary Layer Equations in Free Convection Over a Vertical Flat Plate and Forced Convection Over a Wedge.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 747
- By:
- Publication type:
- Article
Thermal Performance of Pin Fin Heat Sinks: a Review of Literature.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 726
- By:
- Publication type:
- Article
Coupling of the Natural Convection with Turbulence in a Vertical Wall with Protuberances.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 702
- By:
- Publication type:
- Article
Stress-Strain Analysis of the Horizontal Pressure Vessel on Two Saddle Supports.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 695
- By:
- Publication type:
- Article
Performance Analysis in a Rotary Energy Wheel.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 688
- By:
- Publication type:
- Article
Behaviors Clamped-Free Boundary Conditions for a Functionally Graded Material Hollow Cylindrical Shell Under Vibration with Third Order Shear Deformation Theory.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 680
- By:
- Publication type:
- Article
Different Volume Fraction Laws for Functionally Graded Material Cylindrical Shell Under Simply Support-Free Boundary Conditions.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 672
- By:
- Publication type:
- Article
Analysis T.S.D.T. Theory for a Functionally Graded Cylindrical Shell Under Free Vibration with Effects Free-Free Boundary Conditions.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 664
- By:
- Publication type:
- Article
Effects of Heat Treatment on Residual Stress and Mechanical Properties of the Welded Tubes.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 658
- By:
- Publication type:
- Article
Study the Influence of Isolated Defects of Bearing Wear on the Vibration Acceleration Signals.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 654
- By:
- Publication type:
- Article
Application Free Vibration for Two Type Functionally Graded Cylindrical Shell Composed of Stainless Steel and Nickel Under Clamped-Clamped Boundary Conditions.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 646
- By:
- Publication type:
- Article
Experimental Investigation of Self Actuating Traction Drives with Solid and Hollow Rollers.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 637
- By:
- Publication type:
- Article
Model for Sweeping Possible Assemblies with Defects in CAD Environment.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 630
- By:
- Publication type:
- Article
Bearing Damage Detection and Diagnosis by Multi-Scale PCA and Power Quality Distribution of Rotating Machinery.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 621
- By:
- Publication type:
- Article
Analytical Investigation of Thin Rib-Stiffened Plates.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 611
- By:
- Publication type:
- Article
Data Scattering of Fatigue Damaging Segmentation in Order to Develop the Fatigue Damaging and Morlet Wavelet Coefficient Relationship.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 605
- By:
- Publication type:
- Article
Modeling and Simulation of Hybrid Architecture Manufacturing Systems.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 594
- By:
- Publication type:
- Article
A Hybrid Power Series -- Artificial Bee Colony Algorithm to Solve Electrostatic Pull-in Instability and Deflection of Nano Cantilever Actuators Considering Casimir Attractions.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 586
- By:
- Publication type:
- Article
Finite-Element Analysis for Thermal Optimization of Submerged Arc Welding (SAW) Process.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 581
- By:
- Publication type:
- Article
Preliminary Design of Carbon Composite Facing for Dry Clutch Disc of Mini Agricultural Tractor.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 577
- By:
- Publication type:
- Article
Experimental Investigation of Solidification Time Effects on Surface and Subsurface Aluminum Casting Defects.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 569
- By:
- Publication type:
- Article
Numerical Simulation for Viscous Flow Past a Designed AUV Model.
- Published in:
- International Review of Mechanical Engineering, 2011, v. 5, n. 4, p. 562
- By:
- Publication type:
- Article