Fuel Characteristics and Gasification of Woody Biomasses in Down Draft Gasifiers.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 126
- By:
- Publication type:
- Article
Works matching IS 19708734 AND DT 2009 AND VI 3 AND IP 1
Results: 16
1
2
A Critical Review of Two-Phase Gas-Liquid Industrial Spray System.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 110
- By:
- Publication type:
- Article
3
Analysis of the Dynamic Response of Bridges Under Moving Loads.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 91
- By:
- Publication type:
- Article
4
Vibratory Analysis of a Composite Beam (Reinforced Concrete) Subject to Corrosion.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 100
- By:
- Publication type:
- Article
5
The Compressibility Effect on the Counting Gas Method Choice.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 104
- By:
- Publication type:
- Article
6
Numeric Modelling Comparative Study of Instrumented Real Work Behaviour: Modelling of Experimental Sheet Pile Wall of Hochstetten.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 79
- By:
- Publication type:
- Article
7
Behavior of Sand and its Effect on Lubricant and Surfaces Wear.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 58
- By:
- Publication type:
- Article
8
Probability Stability of Banks Toward the Sliding.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 74
- By:
- Publication type:
- Article
9
Drying Rate Curves of Ceramic Porous Particle in Superheated Steam and in Air at Different Humidities and the Inversion Temperature.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 64
- By:
- Publication type:
- Article
10
Dynamic Spray/Wall Heat Transfer Correlation for "Cold Combustion" Modes with Port-Fuel Injection.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 48
- By:
- Publication type:
- Article
11
Effect of Foaming Time and Temperature on the Hardness of Al-Si-Cu-Mg Alloy Foam Cell Walls.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 39
- By:
- Publication type:
- Article
12
A New Mesh Generation Algorithm for Core Materials: Finite Element Analysis of Composite Rotor Blade Cross-Sections.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 29
- By:
- Publication type:
- Article
13
Heat and Mass Mixed Convection for Viscoelastic Fluid Past a Stretching Sheet with Ohmic Dissipation Through a Porous Space.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 22
- By:
- Publication type:
- Article
14
Computation of Tension Intensity Coefficients in Cracked Thin-Walled Pipes.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 16
- By:
- Publication type:
- Article
15
Investigation of Buckling of Steel Cylindrical Shells with Elliptical Cutout Under Bending Moment.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 7
- By:
- Publication type:
- Article
16
Dynamic Analysis of the Guiding Mechanisms Used for the Rear Axle of the Commercial Vehicles.
- Published in:
- International Review of Mechanical Engineering, 2009, v. 3, n. 1, p. 1
- By:
- Publication type:
- Article