Works matching IS 19395981 AND DT 2021 AND VI 15 AND IP 1
Results: 33
Metalcasting Industry Research.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 349, doi. 10.1007/s40962-020-00562-8
- Publication type:
- Article
The Corrosion of Al–Cu-Based Alloys and Comments on the Paper "Effect of Solidification Time on Microstructure, Wettability and Corrosion Properties of A205-T7 Aluminum Alloys" by Amir Kordijazi et al.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 13, doi. 10.1007/s40962-020-00475-6
- By:
- Publication type:
- Article
From the Editor: Virtual.
- Published in:
- 2021
- By:
- Publication type:
- Editorial
Artificial Neural Network Modeling of Grain Refinement Performance in AlSi10Mg Alloy.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 338, doi. 10.1007/s40962-020-00472-9
- By:
- Publication type:
- Article
Uncoupled Modeling of the Effects of Coating Layer on the Growth Instability in Pure Metal Solidification.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 326, doi. 10.1007/s40962-020-00470-x
- By:
- Publication type:
- Article
Simulation and Experimental Validation of A356 and AZ91 Alloy Fluidity in a Graphite Mold.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 319, doi. 10.1007/s40962-020-00468-5
- By:
- Publication type:
- Article
Development of Cerium-Reinforced Specialty Aluminum Alloy with Application of X-ray and Neutron Diffraction.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 29, doi. 10.1007/s40962-020-00467-6
- By:
- Publication type:
- Article
Structure and Properties of Carbon Steel Cast by the Ablation Process.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 306, doi. 10.1007/s40962-020-00466-7
- By:
- Publication type:
- Article
Hot Tearing Behavior of Mg-4Zn-xSn-0.6Zr Alloys.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 292, doi. 10.1007/s40962-020-00464-9
- By:
- Publication type:
- Article
Interfacial Microstructure Formation in Al7SiMg/Cu Compound Castings.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 40, doi. 10.1007/s40962-020-00463-w
- By:
- Publication type:
- Article
The Influence of AlFeNiCrCoTi High-Entropy Alloy on Microstructure, Mechanical Properties and Tribological Behaviors of Aluminum Matrix Composites.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 281, doi. 10.1007/s40962-020-00462-x
- By:
- Publication type:
- Article
Microstructure of spheroidal graphite aluminum-alloyed cast irons (SGAACI) containing up to 7.5 wt% produced via in-mold process.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 271, doi. 10.1007/s40962-020-00461-y
- By:
- Publication type:
- Article
Thermomagnetic Processing of Aluminum Alloys During Heat Treatment.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 49, doi. 10.1007/s40962-020-00460-z
- By:
- Publication type:
- Article
Correction to: Iron Reduction in 356 Secondary Aluminum Alloy by Mn and Cr Addition for Sediment Separation.
- Published in:
- 2021
- By:
- Publication type:
- Correction Notice
Effect of Solidification Time on Microstructure, Wettability, and Corrosion Properties of A205-T7 Aluminum Alloys.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 2, doi. 10.1007/s40962-020-00457-8
- By:
- Publication type:
- Article
Accurate Simulation of Complex Temperature Field in Counter-Pressure Casting Process Using A356 Aluminum Alloy.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 259, doi. 10.1007/s40962-020-00456-9
- By:
- Publication type:
- Article
Variogram Roughness Method for Casting Surface Characterization.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 17, doi. 10.1007/s40962-020-00451-0
- By:
- Publication type:
- Article
Effect of Tungsten Equivalent on Heat Treatment Behavior of Semi-multi-alloyed White Cast Iron for Abrasive Wear Resistance.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 229, doi. 10.1007/s40962-020-00449-8
- By:
- Publication type:
- Article
Effect of Process Parameters on Distortion and Residual Stress in High-Pressure Die Cast AZ91D Components After Clean Blasting and Painting.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 241, doi. 10.1007/s40962-020-00448-9
- By:
- Publication type:
- Article
Enhancing the Mechanical Properties of Si Particle Reinforced ZA22 Composite by Ti–B Modification.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 206, doi. 10.1007/s40962-020-00447-w
- By:
- Publication type:
- Article
Numerical Analysis of the Cooling System Performance and Effectiveness in Aluminum Low-Pressure Die Casting.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 216, doi. 10.1007/s40962-020-00446-x
- By:
- Publication type:
- Article
Heat Treatment Optimization of CA-6NM Cast Alloy Using a Full Factorial Design of Experiments Approach.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 76, doi. 10.1007/s40962-020-00445-y
- By:
- Publication type:
- Article
The Effects of Zr Addition on the Microstructure and Mechanical Properties of A356–SiC Composites.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 169, doi. 10.1007/s40962-020-00439-w
- By:
- Publication type:
- Article
Effect of Cu on the Hot Tearing Susceptibility of Al–6Zn–2.5Mg–xCu Alloy.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 130, doi. 10.1007/s40962-020-00438-x
- By:
- Publication type:
- Article
Characterization of High-Cycle Bending Fatigue Behaviors for Piston Aluminum Matrix SiO2 Nano-composites in Comparison with Aluminum–Silicon Alloys.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 152, doi. 10.1007/s40962-020-00437-y
- By:
- Publication type:
- Article
Comparative Study on Relationship Between Modification of Si Phase and Thermal Conductivity of Al–7Si Alloy Modified by Sr/RE/B/Sb Elements.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 194, doi. 10.1007/s40962-020-00436-z
- By:
- Publication type:
- Article
Characterization and Properties of Ceramic Shells in Investment Casting Process.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 98, doi. 10.1007/s40962-020-00421-6
- By:
- Publication type:
- Article
Simulation Study on Filling and Solidification of Horizontal Centrifugal Casting Babbitt Lining of Bimetallic Bearing.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 119, doi. 10.1007/s40962-020-00429-y
- By:
- Publication type:
- Article
The Effects of Rotary Degassing Treatments on the Melt Quality of an Al–Si Casting Alloy.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 141, doi. 10.1007/s40962-020-00428-z
- By:
- Publication type:
- Article
Effect of Transition Metals Addition on Tensile Properties of Al–Si–Cu-Based Alloys at 25 °C and 250 °C: Role of Heat Treatment.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 60, doi. 10.1007/s40962-020-00427-0
- By:
- Publication type:
- Article
Optimization of Semi-solid High-Pressure Die Casting Process by Computer Simulation, Taguchi Method and Grey Relational Analysis.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 108, doi. 10.1007/s40962-020-00422-5
- By:
- Publication type:
- Article
Iron Reduction in 356 Secondary Aluminum Alloy by Mn and Cr Addition for Sediment Separation.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 182, doi. 10.1007/s40962-020-00433-2
- By:
- Publication type:
- Article
A Preliminary Study Upon the Applicability of the Direct Water Cooling with the Lost Foam Casting Process.
- Published in:
- International Journal of Metalcasting, 2021, v. 15, n. 1, p. 88, doi. 10.1007/s40962-020-00420-7
- By:
- Publication type:
- Article