Effect of squid fin bionic surface and magnetic nanofluids on CPU cooling performance under magnetic field.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2482
- By:
- Publication type:
- Article
Works matching IS 19322135 AND DT 2020 AND VI 15 AND IP 4
Results: 25
1
2
Water loss due to evaporation from open reservoirs under weather conditions in Vietnam.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2488
- By:
- Publication type:
- Article
3
Experimental investigation of additives enhanced vacuum flash evaporation for binary ice generation.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2485
- By:
- Publication type:
- Article
4
Enhanced hydroformylation of 1‐hexene in microbubble media.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2484
- By:
- Publication type:
- Article
5
Fast and affordable recycling approach to electronic waste above the melting point using induction heat combined with centrifugal forces.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2483
- By:
- Publication type:
- Article
6
Effect of alcohols on combustion characteristics and particle size distribution of a diesel engine fueled with diesel‐castor oil blended fuel.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2477
- By:
- Publication type:
- Article
7
Copper sulfate as additive for Fe<sub>3</sub>O<sub>4</sub> electrodes of rechargeable Ni–Fe batteries.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2475
- By:
- Publication type:
- Article
8
Analysis of bubble formation during injection molding of polymeric foams by computational fluid dynamics simulations.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2474
- By:
- Publication type:
- Article
9
Influence of oxygen enrichment on performance, combustion, and emission characteristics of a stationary diesel engine fuelled with Calophyllum Inophyllum biodiesel blend.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2472
- By:
- Publication type:
- Article
10
Coal fly ash‐derived mesoporous SBA‐15 as support material for production of liquid hydrocarbon through Fischer–Tropsch route.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2471
- By:
- Publication type:
- Article
11
Fabrication of chitosan particles through a coaxial nozzle under pressurized carbon dioxide.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2466
- By:
- Publication type:
- Article
12
Performance evaluation of an air breathing–direct methanol fuel cell with different cathode current collectors with liquid electrolyte layer.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2465
- By:
- Publication type:
- Article
13
Influence of overflow port selection on the gas desulfurization of gas cyclone–liquid jet absorption separator.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2462
- By:
- Publication type:
- Article
14
Coagulation as pretreatment for membrane‐based wetland saline water desalination.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2461
- By:
- Publication type:
- Article
15
A study of the influence of temperature and detergent concentration on the removal of lipstick stains using air‐supersaturated water, where fine bubbles are generated by ultrasonic stimulation.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2459
- By:
- Publication type:
- Article
16
Grindability, thermogravimetric characteristics, and kinetics analysis of semi‐biochar from coarse wood pyrolyzed in a fluidized bed.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2458
- By:
- Publication type:
- Article
17
Gas fuel production derived from pine sawdust pyrolysis catalyzed on alumina.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2456
- By:
- Publication type:
- Article
18
Gas–liquid two‐phase flow characteristics of the jet vortex drainage gas production tool based on computational fluid dynamics.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2455
- By:
- Publication type:
- Article
19
High‐temperature char gasification of anthracite/petroleum coke: using biomass leachate as cheap‐effective additive.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2454
- By:
- Publication type:
- Article
20
A data‐driven approach for flow corrosion characteristic parameters prediction in an air cooler.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2450
- By:
- Publication type:
- Article
21
Experimental research on NO emission with coal preheating combustion technology.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2444
- By:
- Publication type:
- Article
22
Issue Information.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2329
- Publication type:
- Article
23
Simulation study on novel groove separator in a dual‐loop wet flue gas desulfurization spray tower.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2442
- By:
- Publication type:
- Article
24
Effect of granulating characteristics on harmless disposal of waste selective catalytic reduction catalyst in iron ore sintering process.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2428
- By:
- Publication type:
- Article
25
Investigation dielectric and morphological properties of fly ash collected from thermal power plant.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2020, v. 15, n. 4, p. 1, doi. 10.1002/apj.2437
- By:
- Publication type:
- Article