Friction and wear behavior and mechanism of low carbon microalloyed steel containing Nb.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 263, doi. 10.1007/s41230-023-2104-8
- By:
- Publication type:
- Article
Works matching IS 16726421 AND DT 2023 AND VI 20 AND IP 3
Results: 10
1
2
Interface characteristics and wear resistance of Ni-B<sub>4</sub>C plated ZTA reinforced high chromium cast iron composite.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 253, doi. 10.1007/s41230-023-2160-0
- By:
- Publication type:
- Article
3
Effect of mixing temperature on microstructure of an Al-Si alloy prepared by controlled diffusion solidification.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 241, doi. 10.1007/s41230-023-2067-9
- By:
- Publication type:
- Article
4
Effect of melt-to-solid volume ratio and preheating temperature on Mg/Al bimetals interface by centrifugal casting.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 234, doi. 10.1007/s41230-023-2101-y
- By:
- Publication type:
- Article
5
Effect of compound treatment of rotating magnetic field and Al-5Ti-1B refiner on microstructure and properties of Al-5Cu alloy.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 225, doi. 10.1007/s41230-023-2123-5
- By:
- Publication type:
- Article
6
Effect of mold and core preheating temperature on corrosion resistance of casting Al-12Si alloy U-shaped cooling channel.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 218, doi. 10.1007/s41230-023-2149-8
- By:
- Publication type:
- Article
7
Effect of heat treatment on microstructure, mechanical and tribological properties of in-situ (TiC+TiB)/TC4 composites by casting.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 207, doi. 10.1007/s41230-023-3003-8
- By:
- Publication type:
- Article
8
Feasibility of measuring moisture content of green sand by a low frequency multiprobe detector based on dielectric characteristics.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 197, doi. 10.1007/s41230-023-2087-5
- By:
- Publication type:
- Article
9
Strengthening and toughening of additively manufactured Ti-6Al-4V alloy by hybrid deposition and synchronous micro-rolling.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 189, doi. 10.1007/s41230-023-2115-5
- By:
- Publication type:
- Article
10
Effect of Ti content on microstructures and mechanical properties of cast Al-2Li-2Cu-0.5Mg alloy.
- Published in:
- China Foundry, 2023, v. 20, n. 3, p. 179, doi. 10.1007/s41230-023-3036-z
- By:
- Publication type:
- Article