Effects of different casting mould cooling rates on microstructure and properties of sand-east Al-7.5Si-4Cu alloy.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 396
- By:
- Publication type:
- Article
Works matching IS 16726421 AND DT 2013 AND VI 10 AND IP 6
Results: 10
1
2
Effect of residual Al content on microstructure and mechanical properties of Grade B+Steel for castings for locomotives.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 391
- By:
- Publication type:
- Article
3
Orthogonal tests of copper-clad aluminum bimetal continuous casting by nitrogen pressure core-filling.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 385
- By:
- Publication type:
- Article
4
Low cycle fatigue behavior of die cast Mg-Al-Mn-Ce magnesium alloy.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 380
- By:
- Publication type:
- Article
5
Microstructure and hardness of WC-Co particle reinforced iron matrix surface composite.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 374
- By:
- Publication type:
- Article
6
Particle motion behavior during gasification of foam carrier in lost foam-squeeze casting of 20%TiC/ZG270-500 composites.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 367
- By:
- Publication type:
- Article
7
Simulation study on three casting processes for a marine propeller hub body.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 360
- By:
- Publication type:
- Article
8
Influence of heat treatment on microstructure and tensile properties of a cast Al-Cu-Si-Mn alloy.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 355
- By:
- Publication type:
- Article
9
Effects of low frequency electromagnetic field on surface quality, microstructure and hot-tearing tendency of semi-continuous casting ZK60 magnesium alloy billets.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 351
- By:
- Publication type:
- Article
10
Microstructure evolution and room temperature deformation of a directionally solidified Nb-Si-Ti-Cr-Al-Hf-Y alloy.
- Published in:
- China Foundry, 2013, v. 10, n. 6, p. 345
- By:
- Publication type:
- Article