Found: 42
Select item for more details and to access through your institution.
Study of mixtures using simplex design for the addition of chamotte in clay bricks.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2349, doi. 10.1111/ijac.13346
- By:
- Publication type:
- Article
Improvement in heat resistivity of alkaline earth silicate fiber boards by Al<sub>4</sub>SiC<sub>4</sub> coating.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2316, doi. 10.1111/ijac.13341
- By:
- Publication type:
- Article
The effects of thioacetamide/copper molar ratio and reaction time on the phase evolution, morphology, optical, and photocatalytic properties of the nanosheets‐based flower‐like copper sulfide.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2322, doi. 10.1111/ijac.13322
- By:
- Publication type:
- Article
Steel spheres impact on alumina ceramic tiles: Experiments and finite element simulations.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2131, doi. 10.1111/ijac.13318
- By:
- Publication type:
- Article
Inkjet technology for ceramic products. Influence of some process variables on ink penetration.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2153, doi. 10.1111/ijac.13342
- By:
- Publication type:
- Article
Round‐robin exercise on the three‐ and four‐point flexural strength of thin ceramic plates for power modules.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2121, doi. 10.1111/ijac.13339
- By:
- Publication type:
- Article
Adaptation of the dynamic mechanical analysis to determine the gel point during the setting of liquid alkali silicates.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2331, doi. 10.1111/ijac.13334
- By:
- Publication type:
- Article
Interface evaluation on the brazed system of AlN‐Ticusil‐Graphite.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2236, doi. 10.1111/ijac.13330
- By:
- Publication type:
- Article
Microstructural evolution and fracture toughness of plasma sprayed CNT reinforced Yttria‐stabilized Hafnia coating.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2306, doi. 10.1111/ijac.13327
- By:
- Publication type:
- Article
Evolution of interfacial structures and mechanical performance of sapphire and Sn–9Zn–2Al joints by ultrasound.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2254, doi. 10.1111/ijac.13324
- By:
- Publication type:
- Article
Enhancement of bonding strength between lead wires and ceramic matrix of metal ceramic heater.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2245, doi. 10.1111/ijac.13319
- By:
- Publication type:
- Article
Novel SiC synthesis method applicable to SiC solid phase sintering.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2111, doi. 10.1111/ijac.13320
- By:
- Publication type:
- Article
Microstructural evolution and kinetics analysis of aluminum borate ceramics via solid‐state reaction synthesis.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2457, doi. 10.1111/ijac.13308
- By:
- Publication type:
- Article
Determining the thermal conductivity of ceramic coatings by relative method.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2299, doi. 10.1111/ijac.13313
- By:
- Publication type:
- Article
Effect of different storage media on the microhardness and wear resistance of resin‐matrix ceramics.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2467, doi. 10.1111/ijac.13307
- By:
- Publication type:
- Article
A simple approach for improving high‐temperature mechanical and insulation performance in chamotte with added zircon.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2342, doi. 10.1111/ijac.13304
- By:
- Publication type:
- Article
In situ synthesis mechanism of ZrC‐ZrB<sub>2</sub>/Cu composites prepared by SHS‐casting method.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2229, doi. 10.1111/ijac.13305
- By:
- Publication type:
- Article
Effect of pH variation on the subcritical crack growth parameters of glassy matrix ceramics.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2449, doi. 10.1111/ijac.13302
- By:
- Publication type:
- Article
Ceramic membranes applied to membrane distillation: A comprehensive review.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2161, doi. 10.1111/ijac.13301
- By:
- Publication type:
- Article
Mechanical hysteresis and damage evolution in C/SiC composites under fatigue loading at room and elevated temperatures.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2214, doi. 10.1111/ijac.13300
- By:
- Publication type:
- Article
Effect of Pr on the electrical and chemical properties of cerium oxide prepared by combustion method.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2482, doi. 10.1111/ijac.13295
- By:
- Publication type:
- Article
Influence of preparing conditions on the hot‐pressed sintering of transparent polycrystalline fluorite ceramics.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2441, doi. 10.1111/ijac.13296
- By:
- Publication type:
- Article
Dynamic compressive response of zirconium diboride‐silicon carbide composites at high‐strain rates.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2206, doi. 10.1111/ijac.13292
- By:
- Publication type:
- Article
Preparation and photoelectrochemical properties of CdS quantum dot‐sensitized ZnO nanotube arrays.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2474, doi. 10.1111/ijac.13289
- By:
- Publication type:
- Article
Comparison of dry sliding wear behavior of plasma sprayed FeCr slag coating with Cr<sub>2</sub>O<sub>3</sub> and Al<sub>2</sub>O<sub>3</sub>‐13TiO<sub>2</sub> coatings.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2283, doi. 10.1111/ijac.13273
- By:
- Publication type:
- Article
Fabrication and properties of porous anorthite/mullite ceramics with both high porosity and high strength.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2197, doi. 10.1111/ijac.13275
- By:
- Publication type:
- Article
The effect of Sb<sub>2</sub>O<sub>3</sub> on the properties of micro‐arc oxidation coatings on magnesium alloys.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2273, doi. 10.1111/ijac.13272
- By:
- Publication type:
- Article
Effect of annealing on UV‐visible absorption and photoluminescence behavior of liquid phase deposited TiO<sub>2</sub> nanorods.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2429, doi. 10.1111/ijac.13271
- By:
- Publication type:
- Article
Thermal properties of processed lunar regolith simulant.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2419, doi. 10.1111/ijac.13267
- By:
- Publication type:
- Article
Effect of TiO<sub>2</sub> addition on microstructure and mechanical properties of alumina‐based cores prepared by sol‐gel method.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2409, doi. 10.1111/ijac.13268
- By:
- Publication type:
- Article
Preparation and properties of dense ZrB<sub>2</sub> composite reinforced by elongated SiC and Al<sub>3</sub>BC<sub>3</sub> grains.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2190, doi. 10.1111/ijac.13265
- By:
- Publication type:
- Article
High strengthening effects and excellent wear resistance of Ti<sub>3</sub>Al(Si)C<sub>2</sub> solid solutions.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2398, doi. 10.1111/ijac.13264
- By:
- Publication type:
- Article
Synthesis of Al<sub>2</sub>O<sub>3</sub> coatings on Ti(C, N)‐based cermets by microwave plasma CVD using Al(acac)<sub>3</sub>.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2265, doi. 10.1111/ijac.13255
- By:
- Publication type:
- Article
Facile synthesis of α‐Si<sub>3</sub>N<sub>4</sub> nanoneedles and their photoluminescence properties.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2373, doi. 10.1111/ijac.13259
- By:
- Publication type:
- Article
Ceramic molds suitable for rapid forming of CFRP composites via microwave irradiation.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2380, doi. 10.1111/ijac.13260
- By:
- Publication type:
- Article
Novel high‐temperature‐resistant Y<sub>2</sub>SiO<sub>5</sub> aerogel with ultralow thermal conductivity.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2393, doi. 10.1111/ijac.13258
- By:
- Publication type:
- Article
Black porcelain solar plate and its thermal performance.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2385, doi. 10.1111/ijac.13256
- By:
- Publication type:
- Article
Silica‐based ceramic core for aviation applications: Facile pore filling and flexural strength improvement.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2181, doi. 10.1111/ijac.13251
- By:
- Publication type:
- Article
Optimized microstructure with nano‐alumina and its effects on properties of corundum spinel castables.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2362, doi. 10.1111/ijac.13249
- By:
- Publication type:
- Article
Fabrication of α‐Si<sub>3</sub>N<sub>4</sub>‐nanowire/γ‐Y<sub>2</sub>Si<sub>2</sub>O<sub>7</sub> composite superhydrophobic membrane for membrane distillation.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2173, doi. 10.1111/ijac.13247
- By:
- Publication type:
- Article
Issue Information.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. 2109, doi. 10.1111/ijac.13040
- Publication type:
- Article
Cover Image, Volume 16, Issue 6.
- Published in:
- International Journal of Applied Ceramic Technology, 2019, v. 16, n. 6, p. i, doi. 10.1111/ijac.13031
- Publication type:
- Article