A novel center-tapped transformer based multilevel inverter with common DC source.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 3040, doi. 10.21595/jve.2018.20029
- By:
- Publication type:
- Article
Works matching IS 13928716 AND DT 2018 AND VI 20 AND IP 8
Results: 19
1
2
Stability and bifurcation of a flexible rod-fastening rotor bearing system with a transverse open crack.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 3026, doi. 10.21595/jve.2018.19429
- By:
- Publication type:
- Article
3
Improvement of vibration isolation performance of QZS platform in chaotic interval based on damping increase control method.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 3009, doi. 10.21595/jve.2018.19295
- By:
- Publication type:
- Article
4
Application of time-frequency method for research on influence of locomotive wheel slip on vibration.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2998, doi. 10.21595/jve.2018.20450
- By:
- Publication type:
- Article
5
Development and analysis of a new technology of freight cars modernization.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2978, doi. 10.21595/jve.2018.19206
- By:
- Publication type:
- Article
6
Vibration mode analysis of multi-degree-offreedom permanent magnet synchronous motor.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2966, doi. 10.21595/jve.2018.19514
- By:
- Publication type:
- Article
7
Vibration characteristic analysis of a circular thin plate with complex pre-stress distribution.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2951, doi. 10.21595/jve.2018.19244
- By:
- Publication type:
- Article
8
Development of miniature spherical ultrasonic motor using wire stators.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2939, doi. 10.21595/jve.2018.20348
- By:
- Publication type:
- Article
9
Vibration control of a hydrostatic bearing using magnetorheological elastomer shell bearing.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2925, doi. 10.21595/jve.2018.19865
- By:
- Publication type:
- Article
10
Optimization design of semi-active controller for in-wheel motors suspension.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2908, doi. 10.21595/jve.2018.19423
- By:
- Publication type:
- Article
11
Fault feature extraction for rolling element bearings based on multi-scale morphological filter and frequency-weighted energy operator.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2892, doi. 10.21595/jve.2018.19924
- By:
- Publication type:
- Article
12
Deep convolutional neural networks for Bearings failure predictionand temperature correlation.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2878, doi. 10.21595/jve.2018.19637
- By:
- Publication type:
- Article
13
A roller bearing fault diagnosis method using interval support vector deterministic optimization based on nested PSO.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2866, doi. 10.21595/jve.2018.19613
- By:
- Publication type:
- Article
14
Vibration analysis using wavelet transform and fuzzy logic for shaft misalignment.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2855, doi. 10.21595/jve.2018.19611
- By:
- Publication type:
- Article
15
An intelligent fault diagnosis method of rotating machinery using L1-regularized sparse filtering.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2839, doi. 10.21595/jve.2018.19339
- By:
- Publication type:
- Article
16
Fault diagnosis of rolling element bearing based on a new noise-resistant time-frequency analysis method.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2825, doi. 10.21595/jve.2018.19288
- By:
- Publication type:
- Article
17
An improved extreme-point symmetric mode decomposition method and its application to rolling bearing fault diagnosis.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2810, doi. 10.21595/jve.2018.19234
- By:
- Publication type:
- Article
18
Dynamic characteristics analysis on shearer drum in condition of cutting coal with different distributed rocks.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2796, doi. 10.21595/jve.2018.19531
- By:
- Publication type:
- Article
19
Specific damping capacity calculation of composite plates with delamination based on higher-order Zig-Zag theory.
- Published in:
- Journal of Vibroengineering, 2018, v. 20, n. 8, p. 2784, doi. 10.21595/jve.2018.19508
- By:
- Publication type:
- Article