Heat transfer enhancement in a fin and tube heat exchanger with isosceles vortex generators.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 457, doi. 10.5755/j01.mech.21.6.12240
- By:
- Publication type:
- Article
Works matching IS 13921207 AND DT 2015 AND VI 21 AND IP 6
Results: 11
1
2
The modelling of operation of the compression ignition engine powered with diesel fuel with LPG admixture.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 500, doi. 10.5755/j01.mech.21.6.11147
- By:
- Publication type:
- Article
3
Numerical modelling of the hydrodynamic behaviour of the couple piston-liner.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 450, doi. 10.5755/j01.mech.21.6.7035
- By:
- Publication type:
- Article
4
Interpretation of parameters in strain energy density bone adaptation equation when applied to topology optimization of inert structures.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 443, doi. 10.5755/j01.mech.21.6.12106
- By:
- Publication type:
- Article
5
Practical aspects of increasing workers efficient work time in a high noise level industrial area.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 493, doi. 10.5755/j01.mech.21.6.13240
- By:
- Publication type:
- Article
6
Data-driven simulations of flank wear of coated cutting tools in hard turning.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 486, doi. 10.5755/j01.mech.21.6.12199
- By:
- Publication type:
- Article
7
Damage detection and localization in composite beam structures based on vibration analysis.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 472, doi. 10.5755/j01.mech.21.6.12526
- By:
- Publication type:
- Article
8
Addendum modification of spur gears with equalized efficiency at the points where the meshing stars and ends.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 480, doi. 10.5755/j01.mech.21.6.12480
- By:
- Publication type:
- Article
9
Optimum design of damped vibration absorber for viscoelastic bladed disk assemblies.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 465, doi. 10.5755/j01.mech.21.6.13243
- By:
- Publication type:
- Article
10
Investigation of cutting tool diameter influencing wire cutting operation accuracy using several matrix configurations.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 437, doi. 10.5755/j01.mech.21.6.13477
- By:
- Publication type:
- Article
11
Investigating the effect of passes number on microstructural and mechanical properties of the A12024/SiC composite produced by friction stir processing.
- Published in:
- Mechanika, 2015, v. 21, n. 6, p. 430, doi. 10.5755/j01.mech.2L6.12227
- By:
- Publication type:
- Article