Improved cooperative collision Avoidance (CCA) model considering driver comfort.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 989, doi. 10.1007/s12239-015-0101-7
- By:
- Publication type:
- Article
Works matching IS 12299138 AND DT 2015 AND VI 16 AND IP 6
Results: 18
1
2
Design of a very light L7e electric vehicle prototype.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 997, doi. 10.1007/s12239-015-0102-6
- By:
- Publication type:
- Article
3
Two-layer distributed equalization management system for electric vehicle power battery.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 1007, doi. 10.1007/s12239-015-0103-5
- By:
- Publication type:
- Article
4
Impact of fuel, injection type and after-treatment system on particulate emissions of light-duty vehicles using different fuels on FTP-75 and HWFET test cycles.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 895, doi. 10.1007/s12239-015-0091-5
- By:
- Publication type:
- Article
5
Hardware-in-the-loop simulation to evaluate the drive performance of the electric two-wheelers on a motor dynamometer.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 1031, doi. 10.1007/s12239-015-0105-3
- By:
- Publication type:
- Article
6
Modeling engine fuel consumption and NOx with RBF neural network and MOPSO algorithm.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 1041, doi. 10.1007/s12239-015-0106-2
- By:
- Publication type:
- Article
7
Development of a forward visibility assessment tool based on visibility angle.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 1051, doi. 10.1007/s12239-015-0107-1
- By:
- Publication type:
- Article
8
Correlation between residual speedometer needle reading and impact speed of vehicles in traffic accidents.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 1057, doi. 10.1007/s12239-015-0108-0
- By:
- Publication type:
- Article
9
Operational efficiency comparison on eco-friendly vehicles including dynamic wireless charging.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 1017, doi. 10.1007/s12239-015-0104-4
- By:
- Publication type:
- Article
10
Combustion and emission characteristics of wood pyrolysis oil-butanol blended fuels in a DI diesel engine.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 903, doi. 10.1007/s12239-015-0092-4
- By:
- Publication type:
- Article
11
Improvement of exhaust gas pressure's utilization for compressing the intake air in diesel engine's cylinders.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 913, doi. 10.1007/s12239-015-0093-3
- By:
- Publication type:
- Article
12
Experimental study on the heat pump system using R134a refrigerant for zero-emission vehicles.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 923, doi. 10.1007/s12239-015-0094-2
- By:
- Publication type:
- Article
13
Quality index of dual shell horns of passenger cars based on a spectrum decay slope.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 929, doi. 10.1007/s12239-015-0095-1
- By:
- Publication type:
- Article
14
Performance evaluation of integrated control of direct yaw moment and slip ratio control for electric vehicle with rear in-wheel motors on split-mu road.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 939, doi. 10.1007/s12239-015-0096-0
- By:
- Publication type:
- Article
15
Multi-objective optimization of sound package parameters for interior high frequency noise of heavy-duty truck using grey theory.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 947, doi. 10.1007/s12239-015-0097-z
- By:
- Publication type:
- Article
16
Optimal design of vehicle structure for improving small-overlap rating.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 959, doi. 10.1007/s12239-015-0098-y
- By:
- Publication type:
- Article
17
Determination of stiffness characteristics and surface deflection by using virtual joining properties.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 967, doi. 10.1007/s12239-015-0099-x
- By:
- Publication type:
- Article
18
Fault tolerant control method of dual steering actuator motors for steer-by-wire system.
- Published in:
- International Journal of Automotive Technology, 2015, v. 16, n. 6, p. 977, doi. 10.1007/s12239-015-0100-8
- By:
- Publication type:
- Article