Performance Prediction of Cross-Flow Fans Using Mean Streamline Analysis.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 112, doi. 10.1155/ijrm.2005.112
- By:
- Publication type:
- Article
Works matching IS 1023621X AND DT 2005 AND VI 11 AND IP 2
Results: 9
1
2
Synchronous Analysis for Diagnostics of Rolling Bearings in the Turbojet Engine.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 128
- By:
- Publication type:
- Article
3
Numerical Simulation of Turbopump Inducer Cavitating Behavior.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 135
- By:
- Publication type:
- Article
4
An Improved Integral Method for Prediction of Distorted Inlet Flow Propagation in Axial Compressor.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 117, doi. 10.1155/ijrm.2005.117
- By:
- Publication type:
- Article
5
Optimization of Hydraulic Machinery Bladings by Multilevel CFD Techniques.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 161
- By:
- Publication type:
- Article
6
Application of Evolutionary Algorithms and Statistical Analysis in the Numerical Optimization of an Axial Compressor.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 143, doi. 10.1155/ijrm.2005.143
- By:
- Publication type:
- Article
7
A Multicoefficient Slip-Corrected Reynolds Equation for Micro-Thin Film Gas Lubrication.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 105, doi. 10.1155/ijrm.2005.105
- By:
- Publication type:
- Article
8
Numerical Simulation of Multiplicity and Stability of Mixed Convection in Rotating Curved Ducts.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 168
- By:
- Publication type:
- Article
9
Numerical Simulation of Turbulent Fluid Flow and Heat Transfer in a Ribbed Rotating Two-Pass Square Duct.
- Published in:
- International Journal of Rotating Machinery, 2005, v. 11, n. 2, p. 152, doi. 10.1155/ijrm.2005.152
- By:
- Publication type:
- Article