Works matching IS 1023621X AND DT 2003 AND VI 9 AND IP 4
Results: 9
Modeling of Unsteady Sheet Cavitation on Marine Propeller Blades.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 263, doi. 10.1080/10236210309511
- By:
- Publication type:
- Article
Panel Discussion on Inducer Design Criteria.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 229, doi. 10.1080/10236210309512
- By:
- Publication type:
- Article
Numerical Calculation of the Three-Dimensional Swirling Flow Inside the Centrifugal Pump Volutes.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 247, doi. 10.1080/10236210309515
- By:
- Publication type:
- Article
Comparison of Two Diffusers in a Transonic Centrifugal Compressor.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 279, doi. 10.1080/10236210309514
- By:
- Publication type:
- Article
Reduction of Discrete-Frequency Fan Noise Using Slitlike Expansion Chambers.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 239, doi. 10.1080/10236210309513
- By:
- Publication type:
- Article
Rotor Dynamics Analysis of Rotating Machine Systems Using Artificial Neural Networks.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 255, doi. 10.1080/10236210309517
- By:
- Publication type:
- Article
Pressure Fluctuation in a Vaned Diffuser Downstream from a Centrifugal Pump Impeller.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 285, doi. 10.1080/10236210309516
- By:
- Publication type:
- Article
Deflections and Strains in Cracked Shafts Due to Rotating Loads: A Numerical and Experimental Analysis.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 303, doi. 10.1080/10236210309518
- By:
- Publication type:
- Article
Phase-Averaged Method Applied to Periodic Flow Between Shrouded Corotating Disks.
- Published in:
- International Journal of Rotating Machinery, 2003, v. 9, n. 4, p. 293, doi. 10.1080/10236210309519
- By:
- Publication type:
- Article