Multiscale architectures boosting thermoelectric performance of copper sulfide compound.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2017, doi. 10.1007/s12598-020-01698-6
- By:
- Publication type:
- Article
Works matching IS 10010521 AND DT 2021 AND VI 40 AND IP 8
Results: 39
1
2
Preparation of {200} crystal faced SnO2 nanorods with extremely high gas sensitivity at lower temperature.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2004, doi. 10.1007/s12598-021-01720-5
- By:
- Publication type:
- Article
3
Zn–Fe and Y-modified Zn–Fe coatings on 42CrMo steel via pack cementation.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2266, doi. 10.1007/s12598-020-01540-z
- By:
- Publication type:
- Article
4
Green corrosion inhibitors intercalated Mg:Al layered double hydroxide coatings to protect Mg alloy.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2254, doi. 10.1007/s12598-020-01538-7
- By:
- Publication type:
- Article
5
Construction of high-performance magnetic sensor based on anisotropic magnetoresistance Ta/MgO/NiFe/MgO/Ta film.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2026, doi. 10.1007/s12598-021-01719-y
- By:
- Publication type:
- Article
6
Nano-silver induced ceramic coloring via control of glaze interface and phase separation.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2292, doi. 10.1007/s12598-021-01726-z
- By:
- Publication type:
- Article
7
Multistage desulfurization mechanism to reduce sulfur content of high ferrotitanium prepared using thermite method.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2313, doi. 10.1007/s12598-020-01583-2
- By:
- Publication type:
- Article
8
Characteristics of oxide pegs in Ti- and Y-doped CoNiCrAl alloys at 1150 °C.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2059, doi. 10.1007/s12598-020-01577-0
- By:
- Publication type:
- Article
9
High-temperature corrosion of Sn–Bi–Zn–Ga alloys as heat transfer fluid.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2221, doi. 10.1007/s12598-020-01542-x
- By:
- Publication type:
- Article
10
A chitosan/amido-graphene oxide-based self-powered humidity sensor enabled by triboelectric effect.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 1995, doi. 10.1007/s12598-020-01645-5
- By:
- Publication type:
- Article
11
Evolution of microstructure and intervariant boundaries of α phase in electron beam melted and heat-treated Ti–6Al–4V alloy.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2118, doi. 10.1007/s12598-020-01612-0
- By:
- Publication type:
- Article
12
Direct chemical vapor deposition growth of graphene on Ni particles using solid carbon sources.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2275, doi. 10.1007/s12598-020-01610-2
- By:
- Publication type:
- Article
13
Luminescence property and magnetic resonance imaging of Gd2O3:Tb3+ nanocrystals doped with Zn2+, Li+.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2049, doi. 10.1007/s12598-020-01591-2
- By:
- Publication type:
- Article
14
Mechanism of adding rhenium to improve hot corrosion resistance of nickel-based single-crystal superalloys.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2076, doi. 10.1007/s12598-020-01584-1
- By:
- Publication type:
- Article
15
A comparison between novel Gd2Zr2O7 and Gd2Zr2O7/YSZ thermal barrier coatings fabricated by plasma spray-physical vapor deposition.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2244, doi. 10.1007/s12598-020-01534-x
- By:
- Publication type:
- Article
16
A strategy to achieve efficient green-emission dual-mode luminescence of Yb3+, Er3+ doped NaBiF4.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2040, doi. 10.1007/s12598-020-01570-7
- By:
- Publication type:
- Article
17
Microstructure and mechanical properties of friction-stir-welded high-Mg-alloyed Al–Mg alloy plates at different rotating rates.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2167, doi. 10.1007/s12598-020-01558-3
- By:
- Publication type:
- Article
18
Pseudo-spinodal mechanism approach to designing a near-β high-strength titanium alloy through high-throughput technique.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2099, doi. 10.1007/s12598-020-01560-9
- By:
- Publication type:
- Article
19
Microstructure and mechanical properties of TiAl/Ni-based superalloy joints vacuum brazed with Ti–Zr–Fe–Cu–Ni–Co–Mo filler metal.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2134, doi. 10.1007/s12598-020-01550-x
- By:
- Publication type:
- Article
20
Tensile deformation behavior of coarse-grained Ti-55 titanium alloy with different hydrogen additions.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2092, doi. 10.1007/s12598-020-01546-7
- By:
- Publication type:
- Article
21
Forging–microstructure–tensile properties correlation in a new near β high-strength titanium alloy.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2109, doi. 10.1007/s12598-020-01533-y
- By:
- Publication type:
- Article
22
Room-temperature ionic conductivity of Ba, Y, Al co-doped Li7La3Zr2O12 solid electrolyte after sintering.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2301, doi. 10.1007/s12598-020-01526-x
- By:
- Publication type:
- Article
23
Aging precipitation characteristics and tensile properties of Al–Zn–Mg–Cu alloys with different additional Zn contents.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2160, doi. 10.1007/s12598-020-01495-1
- By:
- Publication type:
- Article
24
Microstructures and properties of 6016 aluminum alloy with gradient composition.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2154, doi. 10.1007/s12598-020-01515-0
- By:
- Publication type:
- Article
25
Microstructural evolution and aging behavior of Mg–4.5Y–2.5Nd–1.0Gd–0.5Zr alloys with different Zn additions.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2188, doi. 10.1007/s12598-020-01510-5
- By:
- Publication type:
- Article
26
Microstructural evolution and numerical simulation of laser-welded Ti2AlNb joints under different heat inputs.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2143, doi. 10.1007/s12598-020-01508-z
- By:
- Publication type:
- Article
27
Microstructure and properties of Inconel 625 + WC composite coatings prepared by laser cladding.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2281, doi. 10.1007/s12598-020-01507-0
- By:
- Publication type:
- Article
28
Removal and occurrence state transformation of Ti impurity in Gd metal.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2320, doi. 10.1007/s12598-020-01519-w
- By:
- Publication type:
- Article
29
Microstructure, mechanical properties and stretch formability of as-rolled Mg alloys with Zn and Er additions.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2179, doi. 10.1007/s12598-020-01438-w
- By:
- Publication type:
- Article
30
High-temperature deformation behavior and processing map of the as-cast Inconel 625 alloy.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2083, doi. 10.1007/s12598-020-01474-6
- By:
- Publication type:
- Article
31
Preparation and properties of hot-deformed magnets processed from nanocrystalline/amorphous Nd–Fe–B powders.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2033, doi. 10.1007/s12598-020-01473-7
- By:
- Publication type:
- Article
32
Zr55Al10Ni5Cu30 amorphous alloy film prepared by magnetron sputtering method.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2237, doi. 10.1007/s12598-020-01459-5
- By:
- Publication type:
- Article
33
Improvement of isothermal oxidation resistance of a γ′-strengthened Co–Al–W–Mo–Ta–B alloy at 800 °C via doping Ce.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2065, doi. 10.1007/s12598-020-01436-y
- By:
- Publication type:
- Article
34
Deposition and characterization for high-quality Ti–Ni–Cu thin films with higher Cu content.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2127, doi. 10.1007/s12598-020-01489-z
- By:
- Publication type:
- Article
35
Microstructure, mechanical properties and fracture behavior of a new WE43 alloy.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2197, doi. 10.1007/s12598-020-01423-3
- By:
- Publication type:
- Article
36
Microstructural evolution and properties of a Cu–Cr–Ag alloy during continuous manufacturing process.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2213, doi. 10.1007/s12598-019-01238-x
- By:
- Publication type:
- Article
37
Microstructure and mechanical properties of spark plasma-sintered La2O3 dispersion-strengthened W–Ni–Fe alloy.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2230, doi. 10.1007/s12598-020-01390-9
- By:
- Publication type:
- Article
38
Improved wear resistance of biodegradable Mg–1.5Zn–0.6Zr alloy by Sc addition.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2206, doi. 10.1007/s12598-020-01420-6
- By:
- Publication type:
- Article
39
Migration regularities of impurity aluminum and copper in purification of metal lanthanum by solid-state electrotransport.
- Published in:
- Rare Metals, 2021, v. 40, n. 8, p. 2307, doi. 10.1007/s12598-017-0959-9
- By:
- Publication type:
- Article