Simulation of heat transfer during rotational molding.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 271
- By:
- Publication type:
- Article
Works matching IS 07306679 AND DT 2003 AND VI 22 AND IP 4
Results: 11
1
2
Rotational foam molding of polypropylene with control of melt strength.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 280
- By:
- Publication type:
- Article
3
News from the polymer processing institute.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 378
- Publication type:
- Article
4
Interlaminar shear strength of polycarbonate-toughened epoxy composites reinforced with glass rovings.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 373
- By:
- Publication type:
- Article
5
Influence of melt drawing on the morphology of one- and two-step processed LDPE/thermoplastic starch blends.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 297
- By:
- Publication type:
- Article
6
Evaluation of UV inhibitors in polyester gelcoats.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 365
- By:
- Publication type:
- Article
7
Novel methacryloylamidophenylalanine functionalized porous chelating beads for adsorption of heavy metal ions.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 355
- By:
- Publication type:
- Article
8
The effect of boron nitride particles and hot-pressed boron nitride die on the capillary melt flow processing of polyethylene.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 343
- By:
- Publication type:
- Article
9
Cure kinetics and properties of epoxy resins containing a phosphorous-based flame retardant.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 329
- By:
- Publication type:
- Article
10
Two-phase flow in a gas-injected capillary tube.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 320
- By:
- Publication type:
- Article
11
Investigation of mold plate separation in thin-wall injection molding.
- Published in:
- Advances in Polymer Technology, 2003, v. 22, n. 4, p. 306
- By:
- Publication type:
- Article