Passivity-based stabilization of converter in DC power supply system using feedforward control.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23361
- By:
- Publication type:
- Article
Works matching IS 04247760 AND DT 2021 AND VI 214 AND IP 4
Results: 20
1
2
Load torque control of an electromagnetic motor with a reduction gear andmotor/load-side encoders using a spring model including a dead zone.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23360
- By:
- Publication type:
- Article
3
Collision force suppression system for human-friendly robot.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23359
- By:
- Publication type:
- Article
4
Study on correction and tolerance of phase fluctuation in a radio evaluation system with under-sampling.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23358
- By:
- Publication type:
- Article
5
A study on emergency control of battery energy storage systems for primary frequency regulation after unexpected loss of generation: - Effect of Applying Voltage-Controlled Converters and Rate of Change of Frequency Data -.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23357
- By:
- Publication type:
- Article
6
Development of quartz crystal complex capacitive sensor with microelectrode array for sensitization.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23356
- By:
- Publication type:
- Article
7
Development of impedance measurement of lithium ion batteries electrode using terahertz chemical microscope.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23355
- By:
- Publication type:
- Article
8
Development of dynamic wireless power transfer coils for 3rd generation wireless in-wheel motor.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23354
- By:
- Publication type:
- Article
9
Surge voltage reduction method for dual active bridge matrix converter using circulating current.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23353
- By:
- Publication type:
- Article
10
Improvement of thermal-type MEMS flow sensor chip via new process of silicon etching with sacrificial polycrystalline silicon layer.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23352
- By:
- Publication type:
- Article
11
Current detection circuit in multiple parallel connection circuit of high-power semiconductor modules.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23351
- By:
- Publication type:
- Article
12
Development of a battery management system with flying capacitor-type multiport converter in the discontinuous current mode.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23350
- By:
- Publication type:
- Article
13
Magnetohydrodynamic numerical simulation of bubble-bubble interaction in alkaline water electrolysis with magnetic field.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23349
- By:
- Publication type:
- Article
14
Position sensorless starting method for IPMSMs by all-pass filters.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23348
- By:
- Publication type:
- Article
15
Experimental verification of power factor adjustor with rotor winding circuit in passive variable flux PM motor utilizing space harmonics.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23347
- By:
- Publication type:
- Article
16
Melting and breaking characteristics of strands of high-strength and high-corrosion-resistant OPGWdue to DC arc discharge simulating high-energy lightning strike.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23345
- By:
- Publication type:
- Article
17
Development of in-wheel receiver coil for dynamic wireless power transfer.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23344
- By:
- Publication type:
- Article
18
Development of planning method using mathematical programming for optimization of generation deployment and grid reinforcement matching the energy portfolio of the decarbonized society.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23343
- By:
- Publication type:
- Article
19
Relation between total pressure loss in supersonic nozzle and isentropic efficiency of nonequilibrium disk-shaped MHD generator.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23342
- By:
- Publication type:
- Article
20
Visual map of power transmission of magnetically coupled wireless power transfer system based on independent analysis of transmitter and receiver sides.
- Published in:
- Electrical Engineering in Japan, 2021, v. 214, n. 4, p. 1, doi. 10.1002/eej.23341
- By:
- Publication type:
- Article