Frontmatter.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. i, doi. 10.1515/polyeng-2022-frontmatter4
- Publication type:
- Article
Works matching IS 03346447 AND DT 2022 AND VI 42 AND IP 4
Results: 10
1
2
Approach to quantify the resistance of polymeric foams against thermal load under compression.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 277, doi. 10.1515/polyeng-2021-0312
- By:
- Publication type:
- Article
3
MMA-based fast-curing repair materials suitable for low-temperature application.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 343, doi. 10.1515/polyeng-2021-0292
- By:
- Publication type:
- Article
4
Characterisation of melamine formaldehyde microspheres synthesised with prolonged microencapsulated reaction time.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 288, doi. 10.1515/polyeng-2021-0289
- By:
- Publication type:
- Article
5
Structure and mechanical properties of a multilayer biomedical shaft tubing: effect of layer composition.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 323, doi. 10.1515/polyeng-2021-0266
- By:
- Publication type:
- Article
6
An environmentally sustainable isosorbide-based plasticizer for biodegradable poly(butylene succinate).
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 331, doi. 10.1515/polyeng-2021-0232
- By:
- Publication type:
- Article
7
Improved process moldability and part quality of short-glass–fiber-reinforced polypropylene via overflow short-shot water-assisted injection molding.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 362, doi. 10.1515/polyeng-2021-0217
- By:
- Publication type:
- Article
8
Assessment of processibility and properties of raw post-consumer waste polyethylene in the rotational moulding process.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 374, doi. 10.1515/polyeng-2021-0212
- By:
- Publication type:
- Article
9
Effect of combination printing parameter (infill density and raster angle) on the mechanical and electrical properties of 3D printed PLA/ZnO and cPLA/ZnO composites.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 351, doi. 10.1515/polyeng-2021-0207
- By:
- Publication type:
- Article
10
Changes in the morphology, mechanical strength and biocompatibility of polymer and metal/polymer fabricated hydroxyapatite for orthopaedic implants: a review.
- Published in:
- Journal of Polymer Engineering, 2022, v. 42, n. 4, p. 298, doi. 10.1515/polyeng-2021-0171
- By:
- Publication type:
- Article