Simulation of dynamic gas penetrations on fingering behaviors during gas-assisted injection molding.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 93, doi. 10.1515/polyeng-2016-0395
- By:
- Publication type:
- Article
Works matching IS 03346447 AND DT 2018 AND VI 38 AND IP 1
Results: 11
1
2
Rheological properties and crystallization behaviors of long chain branched polyethylene prepared by melt branching reaction.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 7, doi. 10.1515/polyeng-2016-0221
- By:
- Publication type:
- Article
3
Recycling waste tire rubber by water jet pulverization: powder characteristics and reinforcing performance in natural rubber composites.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 51, doi. 10.1515/polyeng-2016-0383
- By:
- Publication type:
- Article
4
Natural rubber/tetra-needle-like zinc oxide whisker composites: their preparation and characterization.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 25, doi. 10.1515/polyeng-2016-0346
- By:
- Publication type:
- Article
5
Monitoring of the injection and holding phases by using a modular injection mold.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 63, doi. 10.1515/polyeng-2016-0321
- By:
- Publication type:
- Article
6
Influence of mold temperature and process time on the degree of cure of epoxy-based materials for thermoset injection molding and prepreg compression molding.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 73, doi. 10.1515/polyeng-2016-0409
- By:
- Publication type:
- Article
7
Effect of the particle diameter of the chemical foaming agent on the foaming process and the cellular structure of one-shot compression molded polyethylene foams.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 41, doi. 10.1515/polyeng-2016-0411
- By:
- Publication type:
- Article
8
Calendering of non-isothermal Rabinowitsch fluid.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 83, doi. 10.1515/polyeng-2016-0294
- By:
- Publication type:
- Article
9
Antistatic surface properties of plastics using donor-accepter molecular compounding antistatic agent.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 1, doi. 10.1515/polyeng-2016-0366
- By:
- Publication type:
- Article
10
An investigation into the structure and morphology of polyamide 6/polyaniline hybrid fibers.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 19, doi. 10.1515/polyeng-2016-0170
- By:
- Publication type:
- Article
11
Fabrication of short glass fiber reinforced phenol-formaldehyde-lignin and polyurethane-based composite foam: mechanical, friability, and shape memory studies.
- Published in:
- Journal of Polymer Engineering, 2018, v. 38, n. 1, p. 33, doi. 10.1515/polyeng-2016-0289
- By:
- Publication type:
- Article