Doped polyaniline/multiwalled carbon nanotube composites: Preparation and characterization.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1119, doi. 10.1002/pc.22520
- By:
- Publication type:
- Article
Works matching IS 02728397 AND DT 2013 AND VI 34 AND IP 7
Results: 24
1
2
Preparation of Cu/Dickite/LLDPE nanocomposites and synergistic effect of exfoliated dickite and nano-Cu in LLDPE matrix.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1061, doi. 10.1002/pc.22513
- By:
- Publication type:
- Article
3
Effect of different precipitation procedures on the properties of nano-hydroxyapatite/poly-lactic-co-glycolic acid composite.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1158, doi. 10.1002/pc.22524
- By:
- Publication type:
- Article
4
Plasma-polymerized elastomer/conducting polymer composite: Structural and optical characterization.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1091, doi. 10.1002/pc.22517
- By:
- Publication type:
- Article
5
Improvement of microwave absorption for PAni/HA/TiO<sub>2</sub>/Fe<sub>3</sub>O<sub>4</sub> nanocomposite after chemical treatment.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1186, doi. 10.1002/pc.22528
- By:
- Publication type:
- Article
6
Effect of filler dispersion on the electrical conductivity and mechanical properties of carbon/polypropylene composites.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1195, doi. 10.1002/pc.22530
- By:
- Publication type:
- Article
7
Dielectric and mechanical properties of diglycidyl ether of bisphenol a modified by a new fluoro-terminated hyperbranched poly(phenylene oxide).
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1051, doi. 10.1002/pc.22512
- By:
- Publication type:
- Article
8
Non-fickian three-dimensional hindered moisture absorption in polymeric composites: Model development and validation.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1144, doi. 10.1002/pc.22523
- By:
- Publication type:
- Article
9
Novel, synergistic composites of polypropylene and rice husk ash: Sustainable resource hybrids prepared by solid-state shear pulverization.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1211, doi. 10.1002/pc.22534
- By:
- Publication type:
- Article
10
Antistatic-reinforced biocomposites of polyamide-6 and polyaniline-coated curauá fibers prepared on a pilot plant scale.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1081, doi. 10.1002/pc.22516
- By:
- Publication type:
- Article
11
Effect of conducting composite carbon nanotube-poly(o-toluidine) coatings on the corrosion resistance of stainless steel material.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1180, doi. 10.1002/pc.22527
- By:
- Publication type:
- Article
12
Abrasive wear performance and antibacterial assessment of untreated and treated ZnO-reinforced polymer composite.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1020, doi. 10.1002/pc.22509
- By:
- Publication type:
- Article
13
Preparation and characterization of novel polydimethylsiloxane composites used POSS as cross-linker and fumed silica as reinforcing filler.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1041, doi. 10.1002/pc.22511
- By:
- Publication type:
- Article
14
Preparation and properties of nitrile rubber/superfine down powder composites.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1136, doi. 10.1002/pc.22522
- By:
- Publication type:
- Article
15
Preparation and characterization of polypyrrole/TiO<sub>2</sub> nanocomposites by reverse microemulsion polymerization and its photocatalytic activity for the degradation of methyl orange under natural light.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1076, doi. 10.1002/pc.22515
- By:
- Publication type:
- Article
16
Effect of cure kinetic simulation model on optimized thermal cure cycle for thin-sectioned composite parts.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1172, doi. 10.1002/pc.22526
- By:
- Publication type:
- Article
17
Preparation and characterization of polystyrene/modified carbon black composite beads via in situ suspension polymerization.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1110, doi. 10.1002/pc.22519
- By:
- Publication type:
- Article
18
Poly(3-hydroxybutyrate- co-3-hydroxyvalerate)/clay nanocomposites for replacement of mineral oil based materials.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1033, doi. 10.1002/pc.22510
- By:
- Publication type:
- Article
19
Thermal and dynamic mechanical properties of attapulgite reinforced poly(butylene succinate- co-1,2- octanediol succinate) nanocomposites.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1126, doi. 10.1002/pc.22521
- By:
- Publication type:
- Article
20
Preparation of PVDF/CaCO<sub>3</sub> composite hollow fiber membrane via a thermally induced phase separation method.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1204, doi. 10.1002/pc.22532
- By:
- Publication type:
- Article
21
Effect of reynolds number on the dispersion of carbon black in natural rubber latex and filler-rubber interfacial interaction in high-speed jet flow field.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1071, doi. 10.1002/pc.22514
- By:
- Publication type:
- Article
22
Zein nanofibrous membranes as templates for biomineralization of hydroxyapatite crystallites.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1163, doi. 10.1002/pc.22525
- By:
- Publication type:
- Article
23
Quasi-static and dynamic experiment investigations on the crashworthiness response of composite tubes.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1099, doi. 10.1002/pc.22518
- By:
- Publication type:
- Article
24
Coordination cross-linking gadolinium salt/acrylonitrile-butadiene rubber composite: Its preparation, characterization, and functional properties.
- Published in:
- Polymer Composites, 2013, v. 34, n. 7, p. 1013, doi. 10.1002/pc.22495
- By:
- Publication type:
- Article