Poly(lactic acid) and layered silicate nanocomposites prepared by melt mixing: Thermomechanical and morphological properties.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2095, doi. 10.1002/pc.22316
- By:
- Publication type:
- Article
Works matching IS 02728397 AND DT 2012 AND VI 33 AND IP 12
Results: 21
1
2
Glass fiber breakup in corotating twin screw extruder: Simulation and experiment.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2147, doi. 10.1002/pc.22356
- By:
- Publication type:
- Article
3
Minimum weight design of helically and hoop wound toroidal hydrogen storage tanks with variable slippage coefficients.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2218, doi. 10.1002/pc.22365
- By:
- Publication type:
- Article
4
Fabrication and characterization of conducting nanomaterials composed of copper sulfide and polyindole.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2169, doi. 10.1002/pc.22358
- By:
- Publication type:
- Article
5
Rheology and thermal behavior of polyamide reinforced with alumina whiskers.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2207, doi. 10.1002/pc.22364
- By:
- Publication type:
- Article
6
Characterization and electrical properties of honeycomb-patterned poly(ε-caprolactone)/reduced graphene oxide composite film.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2159, doi. 10.1002/pc.22357
- By:
- Publication type:
- Article
7
Fatigue response and constitutive behavior modeling of poly(ethylene terephthalate) unreinforced and nanocomposite fibers using genetic neural networks.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2277, doi. 10.1002/pc.22368
- By:
- Publication type:
- Article
8
Investigation on β-polypropylene/PP- g-MAH/ surface-treated calcium carbonate composites.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2245, doi. 10.1002/pc.22370
- By:
- Publication type:
- Article
9
Fabrication of novel hindered phenol/phenol resin/nitrile butadiene rubber hybrids and their long-period damping properties.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2125, doi. 10.1002/pc.22352
- By:
- Publication type:
- Article
10
Effect of nanoclay on morphological, thermal, and barrier properties of albumin bovine.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2201, doi. 10.1002/pc.22363
- By:
- Publication type:
- Article
11
Effect of filler geometry on the diffusion and transport behavior of aromatic solvents and commercial oil through nitrile rubber nanocomposites.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2236, doi. 10.1002/pc.22369
- By:
- Publication type:
- Article
12
Experimental investigation on the influence of the composition on the morphology and the mechanical properties of short glass fiber-reinforced polypropylene nanocomposites.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2228, doi. 10.1002/pc.22367
- By:
- Publication type:
- Article
13
Conductivity and methanol permeability of sulfonated polystyrene membrane with dispersed montmorillonite nanoclay.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2105, doi. 10.1002/pc.22324
- By:
- Publication type:
- Article
14
Dielectric and electric properties of plasticized PEO-AgCF<sub>3</sub>SO<sub>3</sub>-SiO<sub>2</sub> nanocomposite polymer electrolyte system.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2195, doi. 10.1002/pc.22362
- By:
- Publication type:
- Article
15
Thermal, dielectric, and rheological properties of aluminum nitride/liquid crystalline copoly(ester amide) composite for the application of thermal interface materials.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2140, doi. 10.1002/pc.22355
- By:
- Publication type:
- Article
16
Microstructure, crystallization and dynamic mechanical properties of polyamide/clay nanocomposites after melt-state annealing.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2271, doi. 10.1002/pc.22359
- By:
- Publication type:
- Article
17
Electrically conductive composites of poly(urea-formaldehyde) and cellulose filled with aluminum.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2188, doi. 10.1002/pc.22361
- By:
- Publication type:
- Article
18
Preparation and characterization of magnetic star-shaped amphiphilic copolymer nanoparticles of S-Fe<sub>3</sub>O<sub>4</sub>-PLA- b-MPEG.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2134, doi. 10.1002/pc.22354
- By:
- Publication type:
- Article
19
Mechanical, thermal, and morphological properties of recycled polycarbonate/recycled poly(acrylonitrile-butadiene-styrene) blend nanocomposites.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2114, doi. 10.1002/pc.22342
- By:
- Publication type:
- Article
20
Effect of surface-treated TiO<sub>2</sub> on non-isothermal crystallization behavior of poly trimethylene terephthalate nanocomposites.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2177, doi. 10.1002/pc.22360
- By:
- Publication type:
- Article
21
Study of polypropylene/ethylene-propylene-diene monomer blends reinforced with sisal fibers.
- Published in:
- Polymer Composites, 2012, v. 33, n. 12, p. 2262, doi. 10.1002/pc.22371
- By:
- Publication type:
- Article