Study on microstructure and its correlation with sheet resistance of Zn-Al metallized film.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1051, doi. 10.1080/02670844.2021.1918933
- By:
- Publication type:
- Article
Works in Surface Engineering, 2021, Vol 37, Issue 8
Results: 13
1
2
Self-cleaned zirconia coatings prepared using a co-precursor sol–gel method.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1059, doi. 10.1080/02670844.2021.1915668
- By:
- Publication type:
- Article
3
Effect of CeO<sub>2</sub> on high-temperature wear resistance of WC/Fe-based coatings.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 982, doi. 10.1080/02670844.2020.1848008
- By:
- Publication type:
- Article
4
Construction of eco-friendly flame retardant and dripping-resistant coating on polyester fabrics.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1067, doi. 10.1080/02670844.2021.1911458
- By:
- Publication type:
- Article
5
Heat treatment of Hexa-Methylene Diamine Tetra-Methylene Phosphonic Acid (HMDTMPA) coating on biodegradable Mg to improve corrosion resistance and bioactivity.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1032, doi. 10.1080/02670844.2021.1906000
- By:
- Publication type:
- Article
6
Investigation of mechanical, kinetic and corrosion properties of borided AISI 304, AISI 420 and AISI 430.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1020, doi. 10.1080/02670844.2021.1884332
- By:
- Publication type:
- Article
7
Effect of shot blasting on droplet contact angle of carbon aided phase change nanocomposites.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1002, doi. 10.1080/02670844.2021.1873898
- By:
- Publication type:
- Article
8
Effects of water jet peening on residual stresses, roughness, and fatigue.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 972, doi. 10.1080/02670844.2020.1850196
- By:
- Publication type:
- Article
9
Microstructure and properties of CPED thermal protective ceramic coating toughened by ZrO<sub>2</sub> nanorods on Al–Si alloy.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1043, doi. 10.1080/02670844.2021.1908738
- By:
- Publication type:
- Article
10
Synthesis and degradation behaviour of Zn-modified coating on Mg alloy.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 963, doi. 10.1080/02670844.2020.1840827
- By:
- Publication type:
- Article
11
The microstructure and optical properties of novel Al<sub>2</sub>O<sub>3</sub>–Ag composite coating.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 953, doi. 10.1080/02670844.2020.1840826
- By:
- Publication type:
- Article
12
DLC (H) coated 13Cr SMSS by high-pulsed power CVD technique.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 1012, doi. 10.1080/02670844.2020.1840737
- By:
- Publication type:
- Article
13
The influence of pyrolysing Al<sub>2</sub>O<sub>3</sub> precursor on the high temperature properties of the YSZ-Al<sub>2</sub>O<sub>3</sub> composite coating.
- Published in:
- Surface Engineering, 2021, v. 37, n. 8, p. 991, doi. 10.1080/02670844.2020.1840692
- By:
- Publication type:
- Article