Correction to: Research of Fatigue Life Prediction for Optimization of the Gearbox Design Based on MSC.Patran.
- Published in:
- 2021
- By:
- Publication type:
- Correction Notice
Works matching IS 00392316 AND DT 2021 AND VI 53 AND IP 6
Results: 24
1
2
Microstructure and Mechanical Properties of 2A14-T4 Alloy T-Joint Connected by Stationary Shoulder Friction Stir Welding.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 1032, doi. 10.1007/s11223-022-00370-x
- By:
- Publication type:
- Article
3
Effect of Rhenium and Gadolinium Additions on the Mechanical Properties of Ti-48Al-2Cr-2Nb Sintered Through Spark Plasma Sintering.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 1023, doi. 10.1007/s11223-022-00369-4
- By:
- Publication type:
- Article
4
Effects of Nano and Micro Size of MgO on Mechanical Properties, Wear, and Corrosion of Magnesium Matrix Composite.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 983, doi. 10.1007/s11223-022-00366-7
- By:
- Publication type:
- Article
5
Microstructural Verification, Mechanical and Wear Analysis of MoTaNbV<sub>x</sub>Ti Refractory High-Entropy Alloys.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 1011, doi. 10.1007/s11223-022-00368-5
- By:
- Publication type:
- Article
6
Microwave-Triggered Thermo-Responsive Shape Memory Polymer (Polyurethane)/GNPS/MWCNTS Composites.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 998, doi. 10.1007/s11223-022-00367-6
- By:
- Publication type:
- Article
7
The Effect of Material Models on Springback Prediction.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 961, doi. 10.1007/s11223-022-00364-9
- By:
- Publication type:
- Article
8
Buckling Analysis of Cylinders Reinforced with Stiffening Rings and Foam. Numerical and Experimental Investigation.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 966, doi. 10.1007/s11223-022-00365-8
- By:
- Publication type:
- Article
9
Influence of Yag Concentration and Pressing Time on Wear of Si<sub>3</sub>N<sub>4</sub> Based Ceramics.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 950, doi. 10.1007/s11223-022-00363-w
- By:
- Publication type:
- Article
10
Effects of the Measured Noise on the Failure Mechanism of Pre-Cracked Concrete Specimens Under the Loading Modes I, II, III, and IV.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 938, doi. 10.1007/s11223-022-00362-x
- By:
- Publication type:
- Article
11
Viscoelasticity of Dental Hard Tissues.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 918, doi. 10.1007/s11223-022-00360-z
- By:
- Publication type:
- Article
12
Load-Carrying Capacity of a Loosely Supported on Inner and Pinched on Outer Contours Circular Three-Layer Fiber-Reinforced Plate.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 928, doi. 10.1007/s11223-022-00361-y
- By:
- Publication type:
- Article
13
Fracture Toughness of Layered Materials with a Hardened Surface Layer.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 909, doi. 10.1007/s11223-022-00359-6
- By:
- Publication type:
- Article
14
Determination of Hardness of High-Strength Steels by the Brinell Method. Part 1. Improvement of Measurement Accuracy.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 902, doi. 10.1007/s11223-022-00358-7
- By:
- Publication type:
- Article
15
Efficiency of Protection Methods Against Corrosion-Fatigue Damage of D16T Aluminum Alloy.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 889, doi. 10.1007/s11223-022-00356-9
- By:
- Publication type:
- Article
16
Analysis of Speckle-Structure Images of Material Surface During Cyclic Loading Damage Accumulation Using Neural Networks.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 896, doi. 10.1007/s11223-022-00357-8
- By:
- Publication type:
- Article
17
Thermal Strength of Steam Turbine Shut-Off and Control Valves Body.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 877, doi. 10.1007/s11223-022-00355-w
- By:
- Publication type:
- Article
18
Singularities of the Solution of the Dynamic Problems of the Elasticity Theory for Metal Composite Cylinders Near Free Ends.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 857, doi. 10.1007/s11223-022-00353-y
- By:
- Publication type:
- Article
19
Determination of Fracture Energy Characteristics and Their Anisotropy for 15Kh2NMFA Steel in Impact Bending Tests.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 867, doi. 10.1007/s11223-022-00354-x
- By:
- Publication type:
- Article
20
High-Temperature Deformation Prediction of Woven Composites Considering the Ablation Process.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 852, doi. 10.1007/s11223-022-00352-z
- By:
- Publication type:
- Article
21
The Influence of Shape Imperfections on the Stability of thin Spherical Shells.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 842, doi. 10.1007/s11223-022-00351-0
- By:
- Publication type:
- Article
22
Pulsed Electromagnetic Field Effect on Residual Stresses and Strains of Welded Joints of AMg6 Aluminum Alloy.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 834, doi. 10.1007/s11223-022-00350-1
- By:
- Publication type:
- Article
23
Application of Refined Calculation Guidelines to the Stress-Strain State and Fracture Resistance Analysis of the NPP Primary-Circuit System Elements.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 824, doi. 10.1007/s11223-022-00349-8
- By:
- Publication type:
- Article
24
Computational Evaluation and Analysis of Change in Shape Peculiarities of WWER-1000 Baffle Under Design and Long-Term Operation Conditions.
- Published in:
- Strength of Materials, 2021, v. 53, n. 6, p. 813, doi. 10.1007/s11223-022-00348-9
- By:
- Publication type:
- Article