Evaluation of residual stresses in PVD-coatings. Part 2.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 450, doi. 10.1007/s11223-010-9236-y
- By:
- Publication type:
- Article
Works matching IS 00392316 AND DT 2010 AND VI 42 AND IP 4
Results: 15
1
2
Adhesive strength and residual stresses accompanying electric contact sintering of powder coatings.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 413, doi. 10.1007/s11223-010-9231-3
- By:
- Publication type:
- Article
3
Diagnostics of closing cracks in rodlike elements at nonlinear resonances by the method of variation of the asymmetry of driving forces.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 397, doi. 10.1007/s11223-010-9229-x
- By:
- Publication type:
- Article
4
Creep failure time of thin-walled pipes under combined internal pressure, bending, and tension.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 439, doi. 10.1007/s11223-010-9235-z
- By:
- Publication type:
- Article
5
Micromechanical characteristics of flux-grown SmAlO single crystal.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 387, doi. 10.1007/s11223-010-9228-y
- By:
- Publication type:
- Article
6
Investigation of the regularities of deformation of heat-resistant steels under conditions of creep in the complex stressed state.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 406, doi. 10.1007/s11223-010-9230-4
- By:
- Publication type:
- Article
7
Low-temperature deformation and strength of alloy steels under complex stress conditions.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 380, doi. 10.1007/s11223-010-9227-z
- By:
- Publication type:
- Article
8
Approximate analytical determination of vibrodiagnostic parameters of the presence of a crack in an elastic body under superharmonic resonance.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 363, doi. 10.1007/s11223-010-9225-1
- By:
- Publication type:
- Article
9
Special features of the spectrum of natural vibrations of seals of gas turbine engines.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 374, doi. 10.1007/s11223-010-9226-0
- By:
- Publication type:
- Article
10
Procedure for strength calculation of laminated composite materials under thermomechanical loading conditions.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 478, doi. 10.1007/s11223-010-9239-8
- By:
- Publication type:
- Article
11
Modeling of crack propagation kinetics.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 426, doi. 10.1007/s11223-010-9233-1
- By:
- Publication type:
- Article
12
Influence of electric current on the mechanical characteristics of rail steel.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 471, doi. 10.1007/s11223-010-9238-9
- By:
- Publication type:
- Article
13
Effect of electric current pulse treatment on the corrosion rate and strength of specimens made of 45 steel.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 432, doi. 10.1007/s11223-010-9234-0
- By:
- Publication type:
- Article
14
Numerical analysis of the long-term strength of the rotor disks of steam turbines.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 418, doi. 10.1007/s11223-010-9232-2
- By:
- Publication type:
- Article
15
A model of asymmetric single-disk rotor self-vibrations.
- Published in:
- Strength of Materials, 2010, v. 42, n. 4, p. 459, doi. 10.1007/s11223-010-9237-x
- By:
- Publication type:
- Article