Influence of the modes of operation and structural factors on the crack propagation in 12Cr–2Ni–Mo steel.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 285, doi. 10.1007/s11223-009-9126-3
- By:
- Publication type:
- Article
Works matching IS 00392316 AND DT 2009 AND VI 41 AND IP 3
Results: 14
1
2
Generalized relative characteristics of limiting states of material under nonisothermal deformation.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 268, doi. 10.1007/s11223-009-9128-1
- By:
- Publication type:
- Article
3
Computerized data bank “Strength of Materials”.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 235, doi. 10.1007/s11223-009-9132-5
- By:
- Publication type:
- Article
4
On diffusion creep of polycrystals.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 243, doi. 10.1007/s11223-009-9133-4
- By:
- Publication type:
- Article
5
Procedure for the determination of torsional deformation relationships for anisotropic materials.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 325, doi. 10.1007/s11223-009-9123-6
- By:
- Publication type:
- Article
6
Analysis of the influence of the level of residual stresses on the ultimate stresses in a cycle for welded structures according to the results of testing of small-size specimens.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 318, doi. 10.1007/s11223-009-9122-7
- By:
- Publication type:
- Article
7
Inelasticity monitoring of structural materials by the resonance method.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 332, doi. 10.1007/s11223-009-9120-9
- By:
- Publication type:
- Article
8
Analysis of the stressed state of a circular thin-walled cylinder under complex loading and with nonlinear hardening of the material.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 278, doi. 10.1007/s11223-009-9129-0
- By:
- Publication type:
- Article
9
Redistribution of stresses in the header–PGV-1000 steam generator connector weldment under loading after thermal treatment.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 251, doi. 10.1007/s11223-009-9130-7
- By:
- Publication type:
- Article
10
Pulse current treatment effect on the strength of reinforcing steel and its weld joint under impact loading.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 303, doi. 10.1007/s11223-009-9124-5
- By:
- Publication type:
- Article
11
Strength characteristics of Mg–Li alloys.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 294, doi. 10.1007/s11223-009-9127-2
- By:
- Publication type:
- Article
12
A study of stress concentration zones under cyclic loading by thermal imaging method.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 339, doi. 10.1007/s11223-009-9121-8
- By:
- Publication type:
- Article
13
Experimental analysis of behavior and damage of sandwich composite materials in three-point bending. Part 2. Fatigue test results and damage mechanisms.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 257, doi. 10.1007/s11223-009-9131-6
- By:
- Publication type:
- Article
14
Forced oscillations of beam with essentially nonlinear absorber.
- Published in:
- Strength of Materials, 2009, v. 41, n. 3, p. 310, doi. 10.1007/s11223-009-9125-4
- By:
- Publication type:
- Article