Works matching IS 00222461 AND DT 2000 AND VI 35 AND IP 12

Results: 34

Prediction of the fracture toughness of fibrous composites.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3161, doi. 10.1023/A:1004884322817

By:

Chiang, C. R.

Publication type:

Article

Preparation of silicon oxycarbide glass fibers from organically modified silicates.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3155, doi. 10.1023/A:1004832305979

By:

Yi Hu

Publication type:

Article

Synthesis of nanocrystalline cubic substoichiometric WC1 − z powders by mechanochemical technology.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3151, doi. 10.1023/A:1004880221909

By:

Guo-Long Tan;
Xi-Jun Wu;
Min-Hua Zhao;
Hong-Fei Zhang

Publication type:

Article

Microstructure and mechanical properties of SiC-platelet reinforced Al2O3/SiC-particle hybrid composites.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3143, doi. 10.1023/A:1004828205070

By:

Choa, Y.-H.;
Nakahira, A.;
Niihara, K.

Publication type:

Article

Sintering properties of submicron TiC powders from carbon coated titania precursor.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3131, doi. 10.1023/A:1004876121000

By:

Koc, R.;
Meng, Chang;
Swift, G. A.

Publication type:

Article

A comparative study on thermally sprayed alumina based ceramic coatings.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3127, doi. 10.1023/A:1004824104162

By:

Abdel-Samad, A. A.;
El-Bahloul, A. M. M.;
Lugscheider, E.;
Rassoul, S. A.

Publication type:

Article

Short range ordering in amorphous In-Se films by wide-angle X-ray scattering.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3121, doi. 10.1023/A:1004872020092

By:

Burian, A.;
Burian, A. M.;
Weszka, J.;
Żelechower, M.;
Lecante, P.

Publication type:

Article

Layered polymer-kaolinite nanocomposites.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3113, doi. 10.1023/A:1004820003253

By:

Gardolinski, J. E.;
Carrera, L. C. M.;
Cantão, M. P.;
Wypych, F.

Publication type:

Article

Direct nitridation of aluminum compacts at low temperature.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3105, doi. 10.1023/A:1004867919183

By:

Okada, T.;
Toriyama, M.;
Kanzaki, S.

Publication type:

Article

The influence of matrix on the quantum size effect of CdSe microcrystals-doped thin films.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3097, doi. 10.1023/A:1004815902345

By:

Nasu, H.;
Iwano, T.;
Hashimoto, T.;
Kamiya, K.

Publication type:

Article

Crystallisation kinetics in AO-Al2O3-SiO2-B2O3 glasses (A = Ba, Ca, Mg).

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3089, doi. 10.1023/A:1004851418274

By:

Lahl, N.;
Singh, K.;
Singheiser, L.;
Hilpert, K.;
Bahadur, D.

Publication type:

Article

The effect of boron addition on brittle-to-ductile transition temperature and its strain rate sensitivity in gamma titanium aluminide.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3083, doi. 10.1023/A:1004886801436

By:

Yu Wang;
Dongliang Lin;
Chi C. Law

Publication type:

Article

Dielectric properties of polyarylate blends.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3077, doi. 10.1023/A:1004859617366

By:

Nagasawa, T.;
Murata, Y.;
Tadano, K.;
Kawai, R.;
Ikehara, K.;
Yano, S.

Publication type:

Article

Dendrite morphologies of the metastable phase from undercooled Fe-30at % Co melts and its stabilities.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3069, doi. 10.1023/A:1004807600527

By:

Li Mingjun;
Yang Gencang;
Zhou Yaohe

Publication type:

Article

Changes of the mechanical properties during the crystallization of bio-active glass-ceramics.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3059, doi. 10.1023/A:1004855516457

By:

Unyi, T.;
Juhász, A.;
Tasnádi, P.;
Lendvai, J.

Publication type:

Article

Effect of calcining temperature on the tetragonal-to-monoclinic phase transition characteristics in 2 mol% yittria-doped zirconia ceramics.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3053, doi. 10.1023/A:1004803532387

By:

Kubo, T.;
Ichikawa, K.;
Machida, N.;
Sakai, H.;
Shigematsu, T.

Publication type:

Article

Superstructure determination of the perovskite βLa0.33NbO3.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3047, doi. 10.1023/A:1004863715548

By:

Carrillo, L.;
Villafuerte-Castrejón, M. E.;
González, G.;
Sansores, L. E.;
Bucio, L.;
Duque, J.;
Pomés, R.

Publication type:

Article

Synthesis of Bi1.5Pb0.5Sr2Ca2Cu3Oy via sol-gel method using different acetate-derived precursors.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3043, doi. 10.1023/A:1004811731478

By:

Halim, S. A.;
Saleh, Al-Khawaldeh;
Azhan, H.;
Mohamed, S. B.;
Khalid, K.;
Suradi, J.

Publication type:

Article

Microstructure, electrical properties, and degradation behavior of praseodymium oxides-based zinc oxide varistors doped with Y2O3.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3037, doi. 10.1023/A:1004749214640

By:

Choon-Woo Nahm;
Choon-Hyun Park

Publication type:

Article

Effect of α-SiC on the microstructure and toughening of hot-pressed SiC-AlN solid solutions.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3029, doi. 10.1023/A:1004743230570

By:

Lim, Chang-Sung

Publication type:

Article

Morphology of calcium carbonate coating on amorphous silicate powder.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3023, doi. 10.1023/A:1004791129661

By:

Suda, S.;
Ichikawa, S.;
Wada, N.;
Umegaki, T.

Publication type:

Article

Preparation and characterization of the strontium stannates SrSnO3 and Sr2SnO4.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3017, doi. 10.1023/A:1004739112823

By:

Pfaff, G.

Publication type:

Article

Stability and single crystal growth of lead scandium niobate and its solid-solution with lead titanate under hydrothermal conditions.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3011, doi. 10.1023/A:1004787028752

By:

Yanagisawa, K.;
Rendon-Angeles, J. C.;
Kanai, H.;
Yamashita, Y.

Publication type:

Article

Low-energy ball-milling: Transformations of boron nitride powders. Crystallographic and chemical characterizations.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 3003, doi. 10.1023/A:1004735011914

By:

Gasgnier, M.;
Szwarc, H.;
Ronez, A.

Publication type:

Article

Vibrational properties of wood along the grain.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2993, doi. 10.1023/A:1004782827844

By:

Obataya, E.;
Ono, T.;
Norimoto, M.

Publication type:

Article

Crystallisation of selenium thin films doped with iodine after evaporation.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2985, doi. 10.1023/A:1004730811005

By:

D'Almeida, K.;
Napo, K.;
Safoula, G.;
Djobo, S.;
Bernede, J. C.

Publication type:

Article

Tensile behavior of SiC/C and Rene'41 following isothermal exposure and thermal fatigue.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2973, doi. 10.1023/A:1004778726935

By:

Pierce, J. L.;
Zawada, L. P.;
Srinivasan, R.

Publication type:

Article

Structure analysis and general characterization of the fluorogallophosphate Mu-2: A new microporous material built from double-four-ring units hosting F− anions.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2965, doi. 10.1023/A:1004726710097

By:

Reinert, P.;
Marler, B.;
Patarin, J.

Publication type:

Article

Simultaneous improvement of the strength and fracture toughness of MgO-Al2O3-SiO2 glass/Mo composites by the microdispersion of flaky Mo particles.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2955, doi. 10.1023/A:1004774626026

By:

Waku, Y.;
Suzuki, M.;
Oda, Y.;
Kohtoku, Y.

Publication type:

Article

In situ measurements and analysis of imidization extent, thickness, and stress during the curing of polyimide films.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2949, doi. 10.1023/A:1004722609188

By:

Kook, H. J.;
Kim, D.

Publication type:

Article

Predicting times to low strain for a 1CrMoV rotor steel using a 6-θ projection technique.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2937, doi. 10.1023/A:1004770525118

By:

Evans, M.

Publication type:

Article

Homogeneous (co)precipitation of inorganic salts for synthesis of monodispersed barium titanate particles.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2927, doi. 10.1023/A:1004718508280

By:

Hu, M. Z.-C.;
Miller, G. A.;
Payzant, E. A.;
Rawn, C. J.

Publication type:

Article

Electrophoretic deposition [EPD] applied to reaction joining of silicon carbide and silicon nitride ceramics.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2913, doi. 10.1023/A:1004766424209

By:

Lessing, P. A.;
Erickson, A. W.;
Kunerth, D. C.

Publication type:

Article

The wetting and spontaneous infiltration of ceramics by molten copper.

Published in:

Journal of Materials Science, 2000, v. 35, n. 12, p. 2909, doi. 10.1023/A:1004714407371

By:

Kennedy, A. R.;
Wood, J. D.;
Weager, B. M.

Publication type:

Article