Works in Journal of Materials Science, 1999, Vol 34, Issue 15
Results: 31
Effect of environmental factors on thermal shock behaviour of polycrystalline alumina ceramics.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3623, doi. 10.1023/A:1004686918618
- By:
- Publication type:
- Article
Determination of surface heterogeneity by contact angle measurements on glassfibres coated with different sizings.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3821, doi. 10.1023/A:1004604917226
- By:
- Publication type:
- Article
An investigation of the fatigue and fracture behavior of multicomponent Nb-11Al-41Ti-1.5Mo-1.5Crintermetallic.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3567, doi. 10.1023/A:1004638714983
- By:
- Publication type:
- Article
Characterization of the spinel phase in a diphasic mullite gel using dynamic X-ray diffraction.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3577, doi. 10.1023/A:1004622531822
- By:
- Publication type:
- Article
Growth of carbon micro-coils by pre-pyrolysis of propane.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3581, doi. 10.1023/A:1004674515892
- By:
- Publication type:
- Article
Effect of ultrasonic treatment on ripening of titanium oxalate salt from solution.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3591, doi. 10.1023/A:1004678616800
- By:
- Publication type:
- Article
Influence of Y2O3 distribution on the rate of tetragonal to monoclinic phase transformation of yttria-stabilized zirconia during hydrothermal aging.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3597, doi. 10.1023/A:1004630800871
- By:
- Publication type:
- Article
Synthesis of aluminum nitride fibres from aluminum silicate fibres by carbothermal reduction method.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3605, doi. 10.1023/A:1004682817709
- By:
- Publication type:
- Article
Mechano-chemical wear of ceramics.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3609, doi. 10.1023/A:1004634901779
- By:
- Publication type:
- Article
SiO2 Entrapment of animal cells Part I Mechanical featurs of sol-gel SiO<sub>2</sub> coatings.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3587, doi. 10.1023/A:1004626632730
- By:
- Publication type:
- Article
A metallurgical study of the contamination zone at the surface of dental Ti castings, due to the phosphate-bonded investment material: the protection efficacy of a ceramic coating.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3639, doi. 10.1023/A:1004639002688
- By:
- Publication type:
- Article
Iron-doped zircon: the mechanism of formation.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3631, doi. 10.1023/A:1004691019526
- By:
- Publication type:
- Article
Effective Young's moduli of quasilayered bars using bar resonance frequencies.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3647, doi. 10.1023/A:1004643103597
- By:
- Publication type:
- Article
Phase decomposition in extruded Zn-Al based alloy.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3653, doi. 10.1023/A:1004695120435
- By:
- Publication type:
- Article
Experimental and theoretical study on the piezoelectric behavior of barium doped PZT.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3659, doi. 10.1023/A:1004647204505
- By:
- Publication type:
- Article
Neutron diffraction study on the medium and short-range order of ternary chalcogenide glasses.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3669, doi. 10.1023/A:1004699205414
- By:
- Publication type:
- Article
On the disappearance of Mo2C during low-temperature sintering of Ti(C,N)-Mo2C-Ni cermets.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3677, doi. 10.1023/A:1004603422252
- By:
- Publication type:
- Article
Grinding effects of host crystals on formation and properties of titania pillared fluorine micas.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3685, doi. 10.1023/A:1004655406322
- By:
- Publication type:
- Article
Simulation of craze failure in a glassy polymer: rate dependent drawing and rate dependent failure models.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3695, doi. 10.1023/A:1004607523161
- By:
- Publication type:
- Article
Interfacial and mechanical properties of environment-friendly “green” composites made from pineapple fibers and poly(hydroxybutyrate-co-valerate) resin.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3709, doi. 10.1023/A:1004659507231
- By:
- Publication type:
- Article
Preparation, characterization and photoelectrochemical behaviors of Fe(III)-doped TiO2 nanoparticles.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3721, doi. 10.1023/A:1004611724069
- By:
- Publication type:
- Article
Fabrication of laminated metal–intermetallic composites by interlayer in-situ reaction.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3731, doi. 10.1023/A:1004624012683
- By:
- Publication type:
- Article
Characterization of bitumens modified with SEBS, EVA and EBA polymers.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3737, doi. 10.1023/A:1004636329521
- By:
- Publication type:
- Article
Effect of ZrO2 and SiO2 on glass forming ability of Zr57Cu20Al10Ni8Ti5 alloy.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3795, doi. 10.1023/A:1004648732247
- By:
- Publication type:
- Article
Melt processing and microstructural analysis of GdBa2Cu3Oy with varying amounts of Gd2BaCuO5 phase.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3755, doi. 10.1023/A:1004640430430
- By:
- Publication type:
- Article
Pressure induced amorphization in calcium phosphates.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3769, doi. 10.1023/A:1004692514500
- By:
- Publication type:
- Article
Undercooling, liquid separation and solidification of Cu-Co alloys.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3747, doi. 10.1023/A:1004688313591
- By:
- Publication type:
- Article
Solid state sintering of ceramics: pore microstructure models, densification equations and applications.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3801, doi. 10.1023/A:1004600816317
- By:
- Publication type:
- Article
Fabrication of gradient distribution alumina short fibre reinforced aluminium alloy.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3813, doi. 10.1023/A:1004652800387
- By:
- Publication type:
- Article
Amorphous chalcogenide Se1−x−y TexPy semiconducting alloys: thermal and mechanical properties.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3779, doi. 10.1023/A:1004644631338
- By:
- Publication type:
- Article
Effect of pure-solvents without deflocculants for finer SiC particle dispersed MgO based composite.
- Published in:
- Journal of Materials Science, 1999, v. 34, n. 15, p. 3789, doi. 10.1023/A:1004696615409
- By:
- Publication type:
- Article