Phenomenon of Narrowing of Holes in Cylindrical Bushings of U8-6MA2 Mud Pump After High-Frequency Hardening.
- Published in:
- Chemical & Petroleum Engineering, 2014, v. 50, n. 3/4, p. 240, doi. 10.1007/s10556-014-9888-8
- By:
- Publication type:
- Article
Works matching DE "MUD pumps"
Results: 24
1
2
Analysis of Geological Exploration Mud Pump Component Wear and Damage.
- Published in:
- Chemical & Petroleum Engineering, 2014, v. 49, n. 11/12, p. 811, doi. 10.1007/s10556-014-9841-x
- By:
- Publication type:
- Article
3
New Generation of High-Pressure Slush and Universal Plunger and Piston Pumps.
- Published in:
- Chemical & Petroleum Engineering, 2005, v. 41, n. 9/10, p. 472, doi. 10.1007/s10556-006-0003-7
- By:
- Publication type:
- Article
4
Non-Productive Time Reduction during Oil Wells Drilling Operations.
- Published in:
- Journal of Petroleum Research & Studies, 2022, n. 36, p. 34, doi. 10.52716/jprs.v12i3.541
- By:
- Publication type:
- Article
5
MUD PUMPING EQUIPMENT ATTACHED TO EXCAVATOR ARM.
- Published in:
- Annals of the University Dunarea de Jos of Galati: Fascicle XIV, Mechanical Engineering / Analele Universităţii "Dunărea de Jos" din Galaţi. Fascicula XIV, Inginerie Mecanică, 2012, v. 17, n. 1, p. 91
- By:
- Publication type:
- Article
6
Research on fault diagnosis of mud pump fluid end based on acoustic emission.
- Published in:
- Advances in Mechanical Engineering (Sage Publications Inc.), 2017, v. 9, n. 6, p. 1, doi. 10.1177/1687814017711393
- By:
- Publication type:
- Article
7
Research on drilling mud pump fault diagnosis based on fusion of acoustic emission and vibration technology.
- Published in:
- Insight: Non-Destructive Testing & Condition Monitoring, 2017, v. 59, n. 8, p. 415, doi. 10.1784/insi.2017.59.8.415
- By:
- Publication type:
- Article
8
Dynamic loading and stress analysis on crankshaft of reciprocating mud pump.
- Published in:
- Journal of Vibroengineering, 2013, v. 15, n. 2, p. 1048
- By:
- Publication type:
- Article
9
Mathematical Modeling of Unsteady Flow in Controlled Mud-Cap Drilling.
- Published in:
- Chemistry & Technology of Fuels & Oils, 2016, v. 52, n. 1, p. 111, doi. 10.1007/s10553-016-0680-7
- By:
- Publication type:
- Article
10
Calculation of the Hydraulic Extension Limit of an Extended-Reach Well with Allowance for the Power Limitations of the Available Mud Pumps.
- Published in:
- Chemistry & Technology of Fuels & Oils, 2016, v. 51, n. 6, p. 713, doi. 10.1007/s10553-016-0662-9
- By:
- Publication type:
- Article
11
Selection of Structural Dimensions of Twin Liners of a Mud Pump Cylinder and Calculation of Strength of Coupling with Assured Tightness.
- Published in:
- Chemical & Petroleum Engineering, 2017, v. 53, n. 7/8, p. 488, doi. 10.1007/s10556-017-0369-8
- By:
- Publication type:
- Article
12
Predicting Frictional Pressure Loss During Horizontal Drilling for Non-Newtonian Fluids.
- Published in:
- Energy Sources Part A: Recovery, Utilization & Environmental Effects, 2011, v. 33, n. 7, p. 631, doi. 10.1080/15567030903226264
- By:
- Publication type:
- Article
13
A COMPARATIVE STUDY OF HARDFACING TECHNOLOGIES APPLIED FOR INCREASING THE WEAR RESISTANCE OF MUD PUMP VALVES.
- Published in:
- Journal of the Balkan Tribological Association, 2016, v. 22, n. 2-I, p. 1228
- By:
- Publication type:
- Article
14
The assessment of the operational suitability of mud pumps on deep water drillships depends on maintenance strategy.
- Published in:
- Scientific Journals of The Maritime University of Szczecin / Zeszyty Naukowe Akademii Morskiej w Szczecinie, 2016, v. 118, n. 46, p. 49, doi. 10.17402/117
- By:
- Publication type:
- Article
15
Technical problems of mud pumps on ultra deepwater drilling rigs.
- Published in:
- Scientific Journals of The Maritime University of Szczecin / Zeszyty Naukowe Akademii Morskiej w Szczecinie, 2013, v. 108, n. 36 z. 2, p. 13
- By:
- Publication type:
- Article
16
Increasing the service life of rapidly wearing components of mud pumps.
- Published in:
- Welding International, 2012, v. 26, n. 1, p. 40, doi. 10.1080/09507116.2011.592711
- By:
- Publication type:
- Article
17
An Experimental Investigation on the Chemical Stability of Selected Formation and Determination of the Proper Type of Water-Base Drilling Fluids. Part 1. Descriptive Tests.
- Published in:
- Energy Sources Part A: Recovery, Utilization & Environmental Effects, 2006, v. 28, n. 9, p. 875, doi. 10.1080/00908310500276932
- By:
- Publication type:
- Article
18
Preparation and property of SiAlON ceramic used on the drilling mud pump cylinder sleeve.
- Published in:
- Materials Research Innovations, 2015, v. 19, p. S9-310, doi. 10.1179/1432891715Z.0000000001999
- By:
- Publication type:
- Article
19
Behavior and Control of the Ballastless Track-Subgrade Vibration Induced by High-Speed Trains Moving on the Subgrade Bed with Mud Pumping.
- Published in:
- Shock & Vibration, 2019, p. 1, doi. 10.1155/2019/9838952
- By:
- Publication type:
- Article
20
Modalities for Estimating the Wear of the Mud Pump Valves.
- Published in:
- Petroleum - Gas University of Ploiesti Bulletin, Technical Series, 2018, v. 70, n. 3, p. 70
- By:
- Publication type:
- Article
21
The Methodology for Evaluating the Resistance of Materials to Erosive Wear.
- Published in:
- Petroleum - Gas University of Ploiesti Bulletin, Technical Series, 2016, v. 68, n. 1, p. 1
- By:
- Publication type:
- Article
22
A Novel Control System of Flexible Impact Positive Displacement Motor for Underground Directional Drilling in Coalmines.
- Published in:
- Journal Européen des Systèmes Automatisés, 2020, v. 53, n. 2, p. 177, doi. 10.18280/jesa.530203
- By:
- Publication type:
- Article
23
Avoiding slush for hot-point drilling of glacier boreholes.
- Published in:
- Annals of Glaciology, 2021, v. 62, n. 84, p. 166, doi. 10.1017/aog.2020.70
- By:
- Publication type:
- Article
24
Perlormance of geosynthetics in unpaved roads.
- Published in:
- International Journal of Geotechnical Engineering, 2010, v. 4, n. 3, p. 337, doi. 10.3328/IJGE.2010.04.03.337-349
- By:
- Publication type:
- Article