Works matching DE "FLUID power technology"
Results: 103
Maintaining Productivity.
- Published in:
- Concrete International, 2008, v. 30, n. 12, p. 55
- By:
- Publication type:
- Article
Effect of aeration on superficial residual stress level of carburised and quenched gears treated by water cavitation peening.
- Published in:
- Surface Engineering, 2006, v. 22, n. 3, p. 219, doi. 10.1179/174329406X108807
- By:
- Publication type:
- Article
Fluid Control: New Challenge to Electronics.
- Published in:
- Management Review, 1965, v. 54, n. 8, p. 10
- By:
- Publication type:
- Article
ANALYSIS OF MARANGONI CONVECTION OF NON-NEWTONIAN POWER LAW FLUIDS WITH LINEAR TEMPERATURE DISTRIBUTION.
- Published in:
- Thermal Science, 2011, v. 15, p. S45, doi. 10.2298/TSCI11S1045Z
- By:
- Publication type:
- Article
Validation of moulding consistency with a self-regulating melt pressure valve.
- Published in:
- Plastics, Rubber & Composites, 2004, v. 33, n. 9/10, p. 438, doi. 10.1179/174328904X29948
- By:
- Publication type:
- Article
Experimental research stand and procedure for hydraulic percussion systems.
- Published in:
- Journal of Mining Science, 2011, v. 47, n. 6, p. 778, doi. 10.1134/S1062739147060104
- By:
- Publication type:
- Article
Methods to gain better efficiency of driving steel pipes into the ground by the pneumatic hammers.
- Published in:
- Journal of Mining Science, 2005, v. 41, n. 6, p. 566, doi. 10.1007/s10913-006-0020-0
- By:
- Publication type:
- Article
Impact Energy of Pneumatic Hammer with Elastic Valve in Back-Stroke Chamber.
- Published in:
- Journal of Mining Science, 2004, v. 40, n. 1, p. 74, doi. 10.1023/B:JOMI.0000041530.35723.d9
- By:
- Publication type:
- Article
Control of Air Feed to Back-Stroke Chamber of the Pneumatic Impact Device.
- Published in:
- Journal of Mining Science, 2003, v. 39, n. 1, p. 64, doi. 10.1023/A:1025713311355
- By:
- Publication type:
- Article
Improvement of Air-Distributing System of the Pneumatic Impact Machines for Trenchless Technologies.
- Published in:
- Journal of Mining Science, 2002, v. 38, n. 5, p. 481
- By:
- Publication type:
- Article
Trajectory of Crack Formed by Hydraulic Fracturing near the Contact of Productive Stratum with Enclosing Rocks.
- Published in:
- Journal of Mining Science, 2002, v. 38, n. 4, p. 359, doi. 10.1023/A:1023311803828
- By:
- Publication type:
- Article
Operation of centrifugal pumps in off-design conditions.
- Published in:
- Chemical & Petroleum Engineering, 2009, v. 45, n. 3/4, p. 148, doi. 10.1007/s10556-009-9163-6
- By:
- Publication type:
- Article
New Generation of High-Pressure Slush and Universal Plunger and Piston Pumps.
- Published in:
- Chemical & Petroleum Engineering, 2005, v. 41, n. 9/10, p. 472, doi. 10.1007/s10556-006-0003-7
- By:
- Publication type:
- Article
Differential Sucker-Rod Pumps.
- Published in:
- Chemical & Petroleum Engineering, 2005, v. 41, n. 9/10, p. 478, doi. 10.1007/s10556-006-0004-6
- By:
- Publication type:
- Article
Experimental Stages for Compressed-Gas Turbines.
- Published in:
- Chemical & Petroleum Engineering, 2003, v. 39, n. 5/6, p. 268, doi. 10.1023/A:1025615132484
- By:
- Publication type:
- Article
An Experimental Study to Enhance the Cutting Performance in Abrasive Waterjet Machining.
- Published in:
- Machining Science & Technology, 2003, v. 7, n. 2, p. 191, doi. 10.1081/MST-120022777
- By:
- Publication type:
- Article
Biotic and abiotic factors act in coordination to amplify hydraulic redistribution and lift.
- Published in:
- New Phytologist, 2010, v. 187, n. 1, p. 3, doi. 10.1111/j.1469-8137.2010.03306.x
- By:
- Publication type:
- Article
Design and prototype development of a customizable training system for teaching fluid power technologies.
- Published in:
- International Journal of Mechanical Engineering Education, 2010, v. 38, n. 4, p. 309, doi. 10.7227/IJMEE.38.4.4
- By:
- Publication type:
- Article
Making rain in the desert.
- Published in:
- Frontiers in Ecology & the Environment, 2003, v. 1, n. 2, p. 60, doi. 10.2307/3868023
- By:
- Publication type:
- Article
Topology optimization of thermal–fluid problem using the MMC-based approach.
- Published in:
- Structural & Multidisciplinary Optimization, 2019, v. 60, n. 1, p. 151, doi. 10.1007/s00158-019-02206-w
- By:
- Publication type:
- Article
Automatic Delineation of Capture Zones for Pump and Treat Systems: A Case Study in Piedmont, Italy.
- Published in:
- Ground Water Monitoring & Remediation, 2010, v. 30, n. 2, p. 46, doi. 10.1111/j.1745-6592.2010.01276.x
- By:
- Publication type:
- Article
REVIEW OF CONTRIBUTIONS REGARDING COANDA EFFECT.
- Published in:
- Review of the Air Force Academy, 2009, v. 16, n. 2, p. 5
- By:
- Publication type:
- Article
FLUD FLOW SIMULATION OF A CROSSFLOW TURBINE.
- Published in:
- Annals of DAAAM & Proceedings, 2009, p. 1921
- By:
- Publication type:
- Article
ASPECTS REGARDING THE ALTERNATING FLOW DRIVEN HYDRAULIC SYSTEMS.
- Published in:
- Annals of DAAAM & Proceedings, 2009, p. 155
- By:
- Publication type:
- Article
Upgrading Coal Using a Pneumatic Density-Based Separator.
- Published in:
- International Journal of Coal Preparation & Utilization, 2008, v. 28, n. 1, p. 51, doi. 10.1080/19392690801934054
- By:
- Publication type:
- Article
Robust optimization for water distribution systems least cost design.
- Published in:
- Water Resources Research, 2013, v. 49, n. 10, p. 6795, doi. 10.1002/wrcr.20539
- By:
- Publication type:
- Article
Cooling Towers: Lower Flow Systems.
- Published in:
- ASHRAE Journal, 2004, v. 46, n. 7, p. 42
- Publication type:
- Article
Optimizing Chillers & Towers.
- Published in:
- ASHRAE Journal, 2004, v. 46, n. 7, p. 34
- By:
- Publication type:
- Article
Primary-Secondary Chilled Water Systems.
- Published in:
- ASHRAE Journal, 2004, v. 46, n. 7, p. 27
- By:
- Publication type:
- Article
Static and Dynamic Experimental Investigation of a Pneumatic Open Loop Proportional Valve.
- Published in:
- Experimental Techniques, 2016, v. 40, n. 5, p. 1377, doi. 10.1007/s40799-016-0142-5
- By:
- Publication type:
- Article
MATRIX FMEA ANALYSIS WITH CAUSE-EFFECT DIAGRAM FOR SELECTED FLUID POWER COMPONENT.
- Published in:
- Technical Transactions / Czasopismo Techniczne, 2017, v. 10, p. 141, doi. 10.4467/2353737XCT.17.179.7287
- By:
- Publication type:
- Article
Spinning up the polymorphs of calcium carbonate.
- Published in:
- Scientific Reports, 2014, p. 1, doi. 10.1038/srep03616
- By:
- Publication type:
- Article
ONLINE SYSTEM FOR FLUID POWER LABORATORIES RESOURCE SHARING.
- Published in:
- eLearning & Software for Education, 2015, n. 2, p. 416, doi. 10.12753/2066-026X-15-153
- By:
- Publication type:
- Article
CFD for hydrodynamic efficiency and design optimization of key elements of SHP.
- Published in:
- International Journal of Energy & Environment, 2010, n. 6, p. 937
- By:
- Publication type:
- Article
Physical Modeling on Hydraulic Performance of Rectangular Bridge Deck Drains.
- Published in:
- Water (20734441), 2016, v. 8, n. 2, p. 67, doi. 10.3390/w8020067
- By:
- Publication type:
- Article
Energy Savings in Hydraulic Hybrid Transmissions through Digital Hydraulics Technology.
- Published in:
- Energies (19961073), 2022, v. 15, n. 4, p. 1348, doi. 10.3390/en15041348
- By:
- Publication type:
- Article
Advances in Fluid Power Systems.
- Published in:
- Energies (19961073), 2021, v. 14, n. 24, p. 8589, doi. 10.3390/en14248589
- By:
- Publication type:
- Article
Mathematical Model for the Kinematics of a Continuous Ship Unloader.
- Published in:
- International Review on Modelling & Simulations, 2009, v. 2, n. 4, p. 465
- By:
- Publication type:
- Article
New Robotics Pioneered by Fluid Power.
- Published in:
- Journal of Robotics & Mechatronics, 2020, v. 32, n. 5, p. 854, doi. 10.20965/jrm.2020.p0854
- By:
- Publication type:
- Article
Fabrication, Experiment, and Simulation of a Flexible Microvalve-Integrated Microarm for Microgrippers Using Electrorheological Fluid.
- Published in:
- Journal of Robotics & Mechatronics, 2020, v. 32, n. 2, p. 333, doi. 10.20965/jrm.2020.p0333
- By:
- Publication type:
- Article
Experimental test on impeller clocking effect in a multistage centrifugal pump.
- Published in:
- Advances in Mechanical Engineering (Sage Publications Inc.), 2016, v. 8, n. 4, p. 1, doi. 10.1177/1687814016644376
- By:
- Publication type:
- Article
A new length detection-micro fluidic device using an autocatalytic reaction.
- Published in:
- Microchimica Acta, 2008, v. 161, n. 1/2, p. 67, doi. 10.1007/s00604-007-0778-z
- By:
- Publication type:
- Article
20 MINUTES WITH... Kim Stelson.
- Published in:
- 2014
- By:
- Publication type:
- Interview
Editor's Note.
- Published in:
- Tribology & Lubrication Technology, 2011, v. 67, n. 1, p. 42
- By:
- Publication type:
- Article
20 Minutes with... Mike Gust.
- Published in:
- 2011
- By:
- Publication type:
- Interview
A Geometric Multigrid Solver for the Piston–Cylinder Interface of Axial Piston Machines.
- Published in:
- Tribology Transactions, 2012, v. 55, n. 2, p. 163, doi. 10.1080/10402004.2011.639049
- By:
- Publication type:
- Article
Digital, Reliable, Sustainable – Recent Innovations in Fluid Power.
- Published in:
- Chemical Engineering & Technology, 2023, v. 46, n. 1, p. 4, doi. 10.1002/ceat.202370104
- By:
- Publication type:
- Article
Electrochemical hydrogen pump for recirculation of hydrogen in a fuel cell stack.
- Published in:
- Journal of Applied Electrochemistry, 2007, v. 37, n. 3, p. 359, doi. 10.1007/s10800-006-9266-0
- By:
- Publication type:
- Article
The Research on Characteristics of Hydraulic Support Advancing Control System in Coal Mining Face.
- Published in:
- Wireless Personal Communications, 2018, v. 102, n. 4, p. 2667, doi. 10.1007/s11277-018-5294-4
- By:
- Publication type:
- Article
ELECTRO-KINETICS: A VIABLE MICRO-FLUIDIC PLATFORM FOR MINIATURE DIAGNOSTIC KITS.
- Published in:
- Canadian Journal of Chemical Engineering, 2006, v. 84, n. 2, p. 146
- By:
- Publication type:
- Article