Works about FASTENERS
Results: 641
Effect of Anti-Bending Bars on Vertical Vibrations of Passenger Carriage Body.
- Published in:
- Technologies (2227-7080), 2025, v. 13, n. 2, p. 73, doi. 10.3390/technologies13020073
- By:
- Publication type:
- Article
Dynamic Response Analysis of Ballastless Tracks Considering the Temperature-Dependent Viscoelasticity of Cement-Emulsified Asphalt Mortar Based on a Vehicle–Track–Subgrade Coupled Model.
- Published in:
- Lubricants (2075-4442), 2025, v. 13, n. 2, p. 58, doi. 10.3390/lubricants13020058
- By:
- Publication type:
- Article
DEWALT Anchoring Solutions.
- Published in:
- Concrete International, 2017, v. 39, n. 2, p. 68
- Publication type:
- Article
Product Showcase.
- Published in:
- 2015
- Publication type:
- Product Review
PNA CONSTRUCTION TECHNOLOGIES, INC.
- Published in:
- Concrete International, 2009, v. 31, n. 7, p. 76
- Publication type:
- Article
IMPACT DRIVER IS EASY TO USE.
- Published in:
- 2009
- Publication type:
- Product Review
POWERS FASTENERS, INC.
- Published in:
- 2007
- Publication type:
- Product Review
THE GREENSTREAK GROUP.
- Published in:
- 2006
- Publication type:
- Product Review
GAS-POWERED TOOL FASTENS LUMBER INTO CONCRETE.
- Published in:
- Concrete International, 2006, v. 28, n. 8, p. 84
- Publication type:
- Article
products.
- Published in:
- 2006
- Publication type:
- Product Review
products.
- Published in:
- 2004
- Publication type:
- Product Review
Numerical Analysis of a Masonry Panel Reinforced with Pultruded FRP Frames.
- Published in:
- Mechanics of Composite Materials, 2018, v. 54, n. 2, p. 207, doi. 10.1007/s11029-018-9732-x
- By:
- Publication type:
- Article
Fastening of a High-Strength Composite rod with a Splitted and Wedged end in a Potted Anchor 1. Experimental Investigation.
- Published in:
- Mechanics of Composite Materials, 2014, v. 49, n. 6, p. 595, doi. 10.1007/s11029-013-9376-9
- By:
- Publication type:
- Article
Incidence and risk factors for the misplacement of pedicle screws in scoliosis surgery assisted by O-arm navigation-analysis of a large series of one thousand, one hundred and forty five screws.
- Published in:
- 2017
- By:
- Publication type:
- journal article
Jointing of high-loaded composite structural components. Part 1. Design and engineering solutions and performance assessment.
- Published in:
- Strength of Materials, 2006, v. 38, n. 3, p. 234, doi. 10.1007/s11223-006-0036-3
- By:
- Publication type:
- Article
Critical Condition Expectancy of Flange Beam at the Loss of Flat Form of Stability with Riveted Flanges under the Influence of Random Forces and Initial Flexures.
- Published in:
- Strength of Materials, 2005, v. 37, n. 5, p. 535, doi. 10.1007/s11223-005-0064-4
- By:
- Publication type:
- Article
Improving Fire Retardance Properties of Polymer Fiber Materials and Products.
- Published in:
- Fibre Chemistry, 2024, v. 56, n. 3, p. 166, doi. 10.1007/s10692-024-10545-8
- By:
- Publication type:
- Article
Abstracts.
- Published in:
- 2014
- Publication type:
- Abstract
Freeze-Thaw Behaviour of Post-Installed Bonded Anchors under Changing Climate Conditions.
- Published in:
- CivilEng, 2022, v. 3, n. 2, p. 332, doi. 10.3390/civileng3020020
- By:
- Publication type:
- Article
Substantiating the optimization solutions for the mine working fastening system interaction with the enclosing rock mass.
- Published in:
- Mining of Mineral Deposits, 2022, v. 16, n. 3, p. 54, doi. 10.33271/mining16.03.054
- By:
- Publication type:
- Article
轮对 - 轨道系统波磨预测模型的建立及预测分析.
- Published in:
- Lubrication Engineering (0254-0150), 2023, v. 48, n. 1, p. 79, doi. 10.3969/j.issn.0254-0150.2023.01.012
- By:
- Publication type:
- Article
Defect classification of railway fasteners using image preprocessing and a lightweight convolutional neural network.
- Published in:
- Turkish Journal of Electrical Engineering & Computer Sciences, 2022, v. 30, n. 3, p. 891, doi. 10.55730/1300-0632.3817
- By:
- Publication type:
- Article
SCREW-HOLDING CAPACITY OF MELAMINE-FACED FIBERBOARD AND PARTICLEBOARD USED IN FURNITURE PRODUCTION.
- Published in:
- Mugla Journal of Science & Technology, 2016, v. 2, n. 2, p. 49
- By:
- Publication type:
- Article
Theoretical calculation of the track mass in the motion of unsprung masses in relation to track dynamic stiffness and damping.
- Published in:
- International Journal of Pavement Engineering, 2010, v. 11, n. 4, p. 319, doi. 10.1080/10298431003749758
- By:
- Publication type:
- Article
Evaluation of actions on concrete sleepers as design loads - influence of fastenings.
- Published in:
- International Journal of Pavement Engineering, 2010, v. 11, n. 3, p. 197, doi. 10.1080/10298430903402161
- By:
- Publication type:
- Article
Improved Real-Time Detection Transformer-Based Rail Fastener Defect Detection Algorithm.
- Published in:
- Mathematics (2227-7390), 2024, v. 12, n. 21, p. 3349, doi. 10.3390/math12213349
- By:
- Publication type:
- Article
Uniform buttons within the context of the collection of the Waldes Museum of Buttons and Fasteners.
- Published in:
- Museology & Cultural Heritage / Muzeologia a Kulturne Dedicstvo, 2020, v. 8, n. 4, p. 5, doi. 10.46284/mkd.2020.8.4.1
- By:
- Publication type:
- Article
Changes in Prosthetic Screw Stability Because of Misfit of Implant-Supported Prostheses.
- Published in:
- International Journal of Prosthodontics, 2002, v. 15, n. 1, p. 38
- By:
- Publication type:
- Article
Designing Clasps for the Asymmetric Distal Extension Removable Partial Denture.
- Published in:
- International Journal of Prosthodontics, 1996, v. 9, n. 4, p. 374
- By:
- Publication type:
- Article
The Effect of Clasp Form on Permanent Deformation.
- Published in:
- International Journal of Prosthodontics, 1992, v. 5, n. 4, p. 345
- By:
- Publication type:
- Article
Review of the Swinglock Removable Partial Denture.
- Published in:
- International Journal of Prosthodontics, 1991, v. 4, n. 1, p. 80
- By:
- Publication type:
- Article
Influence of the Plow Filling and Thread Angle onto the Plow Head Efficiency / Wpływ Współczynnika Wypełnienia Organu Oraz Kąta Nawinięcia Płata Ślimaka Na Sprawność Ładowania Frezującymi Organami Ślimakowymi
- Published in:
- Archives of Mining Sciences, 2015, v. 60, n. 1, p. 143, doi. 10.1515/amsc-2015-0010
- By:
- Publication type:
- Article
The influence of geometric nonconformance of the SB4 tension clamps on their strength and elasticity characteristics.
- Published in:
- Scientific Reports, 2024, v. 14, n. 1, p. 1, doi. 10.1038/s41598-024-80944-8
- By:
- Publication type:
- Article
Examining the effect of threaded bolt fasteners on steel construction.
- Published in:
- Scientific Reports, 2024, v. 14, n. 1, p. 1, doi. 10.1038/s41598-024-67428-5
- By:
- Publication type:
- Article
Design of a Fast Temporary Fastener with the Labor-Saving and Reversible Ability.
- Published in:
- Coatings (2079-6412), 2021, v. 11, n. 9, p. 1101, doi. 10.3390/coatings11091101
- By:
- Publication type:
- Article
A method of railway fastener defect detection based on ResNet-SSD.
- Published in:
- Journal of Measurement Science & Instrumentation, 2023, v. 14, n. 3, p. 360, doi. 10.62756/jmsi.1674-8042.2023041
- By:
- Publication type:
- Article
Fastener region location method based on gray-scale mutation.
- Published in:
- Journal of Measurement Science & Instrumentation, 2021, n. 1, p. 98, doi. 10.3969/j.issn.1674-8042.2021.01.013
- By:
- Publication type:
- Article
STUDY OF THE INFLUENCE OF TECHNOLOGICAL PARAMETERS ON THE MECHANICS OF SHAPING OF BILLETS USING ROLL STAMPING PROCESSES.
- Published in:
- Agricultural Engineering, Research Papers, 2022, v. 54, p. 62, doi. 10.15544/ageng.2022.54.7
- By:
- Publication type:
- Article
Evaluation of abrasion of Glass Ionomer Cement, Nano filled composite resin, Hybrid composite resin and highly filled composite resin against removable partial denture clasp.
- Published in:
- Journal of Oral Health Research, 2011, v. 2, n. 2, p. 66
- Publication type:
- Article
Randnahe Mehrfachbefestigungen unter kombinierter Belastung.
- Published in:
- Beton- Und Stahlbetonbau, 2014, v. 109, n. 5, p. 334, doi. 10.1002/best.201300091
- By:
- Publication type:
- Article
EXPANSION OF A SCOPE OF METHODS PROTECTION THE RAILWAYS FROM ENTERING BY SAND.
- Published in:
- Transport Problems: an International Scientific Journal, 2013, v. 8, n. 2, p. 55
- By:
- Publication type:
- Article
GENERALIZED MATHEMATICAL MODEL OF FASTENING TECHNOLOGY OF CARGO WITH PADS JOINTLY WITH FLEXIBLE AND THRUST ELEMENTS UNDER THE ACTION OF SPATIAL FORCE SYSTEM.
- Published in:
- Transport Problems: an International Scientific Journal, 2011, v. 6, n. 3, p. 28
- By:
- Publication type:
- Article
An Investigation of Railway Fastener Detection Using Image Processing and Augmented Deep Learning.
- Published in:
- Sustainability (2071-1050), 2021, v. 13, n. 21, p. 12051, doi. 10.3390/su132112051
- By:
- Publication type:
- Article
Product Design for Automated Remanufacturing—A Case Study of Electric and Electronic Equipment in Sweden.
- Published in:
- Sustainability (2071-1050), 2021, v. 13, n. 16, p. 9039, doi. 10.3390/su13169039
- By:
- Publication type:
- Article
Experimental Investigation on Embedding Strength Perpendicular to Grain of Parallel Strand Bamboo.
- Published in:
- Advances in Materials Science & Engineering, 2018, p. 1, doi. 10.1155/2018/3647395
- By:
- Publication type:
- Article
Experimental Investigation on the Load-Carrying Capacity of Steel-to-Laminated Bamboo Dowel Connection I: Single Fastener with Slotted-In Steel Plate under Tension.
- Published in:
- Advances in Civil Engineering, 2021, p. 1, doi. 10.1155/2021/6683589
- By:
- Publication type:
- Article
Experimental Study on the Sliding of WJ-8 Small Resistance Fastener Composite Pad.
- Published in:
- Advances in Civil Engineering, 2020, p. 1, doi. 10.1155/2020/1918043
- By:
- Publication type:
- Article
It Is All Relative: How Young Children Encode Extent.
- Published in:
- Journal of Cognition & Development, 2005, v. 6, n. 1, p. 51, doi. 10.1207/s15327647jcd0601_4
- By:
- Publication type:
- Article
TIME-SAVING PRODUCTS.
- Published in:
- 2015
- By:
- Publication type:
- Product Review
A 7-16 COMPOSITE FLANGE RECEPTACLE.
- Published in:
- Microwave Journal, 2008, p. 36
- Publication type:
- Article