Effect of pointed and diffused air injection on premixed flame confined in a Rijke tube.
- Published in:
- Cogent Engineering, 2016, v. 3, n. 1, p. N.PAG, doi. 10.1080/23311916.2016.1156280
- By:
- Publication type:
- Article
Works matching DE "COMBUSTION equipment"
Results: 31
1
2
NON-INCINERATIVE ECOLOGICAL NEUTRALIZATION OF WASTES USING THE MECANO-THERMAL PROCEDURE.
- Published in:
- Annals of the University Dunarea de Jos of Galati: Fascicle II, Mathematics, Physics, Theoretical Mechanics, 2011, v. 34, p. 31
- By:
- Publication type:
- Article
3
EXPERIMENTAL FACILITY FOR ANALYSIS OF BIOMASS COMBUSTION CHARACTERISTICS.
- Published in:
- Thermal Science, 2015, v. 19, n. 1, p. 341, doi. 10.2298/TSCI120928119M
- By:
- Publication type:
- Article
4
EXPERIMENTAL STUDY OF OPERATING RANGE AND RADIATION EFFICIENCY OF A METAL POROUS BURNER.
- Published in:
- Thermal Science, 2015, v. 19, n. 1, p. 11, doi. 10.2298/TSCI120522154H
- By:
- Publication type:
- Article
5
EXPERIMENTAL STUDIES ON RADIATION HEAT TRANSFER ENHANCEMENT ON A STANDARD MUFFLE FURNACE.
- Published in:
- Thermal Science, 2013, v. 17, n. 2, p. 591, doi. 10.2298/TSCI110309167M
- By:
- Publication type:
- Article
6
Vibration-based fault diagnosis method for conrod small-end bearing knock in internal combustion engines.
- Published in:
- Insight: Non-Destructive Testing & Condition Monitoring, 2018, v. 60, n. 8, p. 418, doi. 10.1784/insi.2018.60.8.418
- By:
- Publication type:
- Article
7
Methane calibration burner and C-factor determination with cone calorimeter - validation of the standardized calibration protocol.
- Published in:
- Fire & Materials, 2016, v. 40, n. 3, p. 511, doi. 10.1002/fam.2292
- By:
- Publication type:
- Article
8
Improvement in Efficiency, Resource and Ecological Indices for Extra-Furnace Steel Treatment with Flux-Cored Wire Containing Calcium Reagents.
- Published in:
- Metallurgist, 2012, v. 56, n. 11/12, p. 933, doi. 10.1007/s11015-013-9677-1
- By:
- Publication type:
- Article
9
Technology for maintaining cleanliness of heat exchange surfaces of combustion equipment.
- Published in:
- Waste Forum, 2013, v. 2013, n. 4, p. 225
- By:
- Publication type:
- Article
10
THE POSSIBILITIES OF USING MARC FOR MANUFACTURING PELLETS FOR ENERGY PURPOSES.
- Published in:
- Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, 2016, v. 64, n. 3, p. 841, doi. 10.11118/actaun201664030841
- By:
- Publication type:
- Article
11
Advances in Integrated Vehicle Thermal Management and Numerical Simulation.
- Published in:
- Energies (19961073), 2017, v. 10, n. 10, p. 1636, doi. 10.3390/en10101636
- By:
- Publication type:
- Article
12
Power-to-Steel: Reducing CO<sub>2</sub> through the Integration of Renewable Energy and Hydrogen into the German Steel Industry.
- Published in:
- Energies (19961073), 2017, v. 10, n. 4, p. 451, doi. 10.3390/en10040451
- By:
- Publication type:
- Article
13
Electric Vehicles in Logistics and Transportation: A Survey on Emerging Environmental, Strategic, and Operational Challenges.
- Published in:
- Energies (19961073), 2016, v. 9, n. 2, p. 86, doi. 10.3390/en9020086
- By:
- Publication type:
- Article
14
Application of a Central Composite Design for the Study of NO<sub>x</sub> Emission Performance of a Low NO<sub>x</sub> Burner.
- Published in:
- Energies (19961073), 2015, v. 8, n. 5, p. 3606, doi. 10.3390/en8053606
- By:
- Publication type:
- Article
15
Operation efficiency and cost check of energy consumption of submerged combustion vaporizer.
- Published in:
- Chemical Engineering of Oil & Gas / Shi You Yu Tian Ran Qi Hua Gong, 2014, v. 43, n. 5, p. 505, doi. 10.3969/j.issn.1007-3426.2014.05.009
- By:
- Publication type:
- Article
16
Numerical Evaluation of CO Emissions for Catalytic Combustion over Noble Metal Disc Burners of Turbulent Gaseous Fuel Jet Diffusion Flames.
- Published in:
- Energy Sources Part A: Recovery, Utilization & Environmental Effects, 2013, v. 35, n. 9, p. 868, doi. 10.1080/15567036.2010.516316
- By:
- Publication type:
- Article
17
Photoluminescence properties of Dy<sup>3+</sup>-doped LaOF nanophosphor for white LED applications.
- Published in:
- Current Science (00113891), 2017, v. 113, n. 6, p. 1139, doi. 10.18520/cs/v113/i06/1139-1141
- By:
- Publication type:
- Article
18
HIGH STABILITY AND LOW EMISSIONS BURNERS USING KARLOWITZ EFFECT IN CONICAL BURNERS.
- Published in:
- Mathematical Modeling in Civil Engineering, 2014, n. 3, p. 5
- By:
- Publication type:
- Article
19
Heat Transfer and Thermo-mechanical Behavior of the Domestic Heater Atmospheric Burner.
- Published in:
- FME Transactions, 2017, v. 45, n. 1, p. 65, doi. 10.5937/fmet1701065F
- By:
- Publication type:
- Article
20
The Balanced Burner.
- Published in:
- Chemical Engineering, 2019, v. 126, n. 1, p. N.PAG
- Publication type:
- Article
21
Burner technology enables reduced NOx with short flame length.
- Published in:
- Chemical Engineering, 2013, v. 120, n. 7, p. 12
- Publication type:
- Article
22
Correcting improper Performance of Direct Fired Heaters.
- Published in:
- Chemical Engineering, 2013, v. 120, n. 5, p. 39
- By:
- Publication type:
- Article
23
Minimization of the switching losses in high power induction furnaces using an analog state feedback controller.
- Published in:
- Modares Journal of Electrical Engineering, 2015, v. 15, n. 2, p. 14
- By:
- Publication type:
- Article
24
OCENA WPŁYWU WYBRANYCH CZYNNIKÓW NA RYZYKO ZATRUĆ PRODUKTAMI SPALANIA Z URZĄDZEŃ GAZOWYCH.
- Published in:
- Safety & Fire Technology / Bezpieczeństwo i Technika Pożarnicza, 2014, v. 33, n. 1, p. 67, doi. 10.2845/bitp.33.1.2014.8
- By:
- Publication type:
- Article
25
CFD ANALYSIS OF THE INFLUENCE OF CENTRIFUGAL SEPARATOR GEOMETRY MODIFICATION ON THE PULVERIZED COAL DISTRIBUTION AT THE BURNERS.
- Published in:
- Transactions of FAMENA, 2014, v. 38, n. 1, p. 25
- By:
- Publication type:
- Article
26
Catalytic combustion in a plate type combustor to achieve uniform temperature distribution.
- Published in:
- Journal of Mechanical Science & Technology, 2018, v. 32, n. 5, p. 2407, doi. 10.1007/s12206-018-0453-9
- By:
- Publication type:
- Article
27
Passive control of instabilities in combustion systems with heat exchanger.
- Published in:
- International Journal of Spray & Combustion Dynamics, 2018, v. 10, n. 4, p. 362, doi. 10.1177/1756827717731486
- By:
- Publication type:
- Article
28
A pilot study of indoor air quality in screen golf courses.
- Published in:
- Environmental Science & Pollution Research, 2015, v. 22, n. 9, p. 7176, doi. 10.1007/s11356-014-3947-8
- By:
- Publication type:
- Article
29
Study on optimal energy efficiency of a sludge drying-incineration combined system.
- Published in:
- Journal of Material Cycles & Waste Management, 2014, v. 16, n. 4, p. 684, doi. 10.1007/s10163-014-0293-3
- By:
- Publication type:
- Article
30
Electron Microscopic Analysis of Concentration Field in Cylinder of Layered Lean Mixture Combustion GDI Engine.
- Published in:
- Acta Microscopica, 2019, v. 28, n. 6, p. 1709
- By:
- Publication type:
- Article
31
Waste-to-Energy: Producer Gas Production from Fuel Briquette of Energy Crop in Thailand.
- Published in:
- International Energy Journal, 2017, v. 17, n. 1, p. 37
- By:
- Publication type:
- Article