Results: 16
Effect of Electric Current Pulses and Cryogenic Temperatures on the Strength of Cutting Hard-Alloy Plates.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 434, doi. 10.1007/s11223-015-9674-7
- By:
- Publication type:
- Article
Limiting State Models for Structural Materials Under Symmetrical Cyclic Bending-Torsional Loading.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 422, doi. 10.1007/s11223-015-9673-8
- By:
- Publication type:
- Article
Influence of Preliminary Deformation on the Characteristics of Cyclic Creep and Damageability of Steel 10GN2MFA Under Plane Stress Conditions.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 441, doi. 10.1007/s11223-015-9675-6
- By:
- Publication type:
- Article
A Program for Numerical Calculation of Dynamic Stress-Strain State and Strength of Hollow Multilayer Anisotropic Cylinders and Spheres. Part 2. Comparison of Numerical Results with Experimental and Theoretical for Cylinders.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 406, doi. 10.1007/s11223-015-9671-x
- By:
- Publication type:
- Article
On the Rational Choice of the Azimuthal Crystallographic Orientation of Single-Crystal Cooled Rotor Blades in Aircraft Gas Turbine Engines.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 415, doi. 10.1007/s11223-015-9672-9
- By:
- Publication type:
- Article
Methodology of Including Spatial Nonuniformity of Material Properties in the Brittle Fracture Resistance Calculation for WWER-1000 Reactor Pressure Vessels. Part 1. Theoretical Analysis.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 385, doi. 10.1007/s11223-015-9669-4
- By:
- Publication type:
- Article
Experimental Investigation of Mechanical Behavior of Materials by Small Punch Testing of Miniature Disk Specimens.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 400, doi. 10.1007/s11223-015-9670-y
- By:
- Publication type:
- Article
Effect of Electrodynamic Treatment on the Fracture Resistance of the AMg6 Aluminum Alloy Under Cyclic Loading.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 447, doi. 10.1007/s11223-015-9676-5
- By:
- Publication type:
- Article
Effect of the Choice of the Simulation Model of the Cyclone-4 Launch Vehicle on the Calculated Values of Dynamic Characteristics.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 454, doi. 10.1007/s11223-015-9677-4
- By:
- Publication type:
- Article
Modeling the Mechanism of Inelastic Shear at Fiber Interfaces in Material with Unidirectional Structure by Thin Perfectly Plastic Interlayer.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 460, doi. 10.1007/s11223-015-9678-3
- By:
- Publication type:
- Article
Strain-Gauge Method of Detecting Subcritical Fatigue Cracks in Low-Carbon Steel Welds.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 467, doi. 10.1007/s11223-015-9679-2
- By:
- Publication type:
- Article
Ultimate Load of Three-Layered Annular Fibrous Composite Plate Fastened on Internal and Simply Supported External Contours.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 481, doi. 10.1007/s11223-015-9681-8
- By:
- Publication type:
- Article
Brittle Failure of Graphite Weakened by V-Notches: A Review of Some Recent Results Under Different Loading Modes.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 488, doi. 10.1007/s11223-015-9682-7
- By:
- Publication type:
- Article
A Method of Virtual Design of the Fatigue Life of a Dynamic Structure.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 507, doi. 10.1007/s11223-015-9683-6
- By:
- Publication type:
- Article
The Influence of Amplitude-Dependent Damping on Vibrodiagnostic Parameters of the Presence of a Closing Crack in a Beam Under Subharmonic Resonance.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 375, doi. 10.1007/s11223-015-9668-5
- By:
- Publication type:
- Article
Method for Assessing the Mechanical Characteristics of Braided Core-Sheath Ropes Made of Synthetic Multifilament Yarns.
- Published in:
- Strength of Materials, 2015, v. 47, n. 3, p. 474, doi. 10.1007/s11223-015-9680-9
- By:
- Publication type:
- Article