Works matching IS 01915665 AND DT 2009 AND VI 45 AND IP 5
Results: 11
Near-surface failure of layered viscoelastic materials.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 477, doi. 10.1007/s11029-009-9105-6
- By:
- Publication type:
- Article
Loss of the load-carrying ability of a compressed two-layer bar under corrosion.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 489, doi. 10.1007/s11029-009-9106-5
- By:
- Publication type:
- Article
Tensile and tribological properties of a short-carbon-fiber-reinforced peek composite doped with carbon nanotubes.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 495, doi. 10.1007/s11029-009-9103-8
- By:
- Publication type:
- Article
The strain-rate-dependent material and failure behaviour of 2D and 3D non-crimp glass-fibre-reinforced composites.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 467, doi. 10.1007/s11029-009-9108-3
- By:
- Publication type:
- Article
The effect of pretensioned FRP windings on the behavior of concrete columns in axial compression.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 457, doi. 10.1007/s11029-009-9107-4
- By:
- Publication type:
- Article
Effect of natural and artificial weathering on the long-term flexural performance of polymer mortars.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 515, doi. 10.1007/s11029-009-9104-7
- By:
- Publication type:
- Article
Dynamical response of a prestrained system comprising a substrate and bond and covering layers to a moving load.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 527, doi. 10.1007/s11029-009-9110-9
- By:
- Publication type:
- Article
Compression moulding simulations of SMC using a multiobjective surrogate-based inverse modeling approach.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 503, doi. 10.1007/s11029-009-9109-2
- By:
- Publication type:
- Article
Application of the resonance method for determining the elastic and dissipative properties of an orthotropic polymer composite.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 445, doi. 10.1007/s11029-009-9100-y
- By:
- Publication type:
- Article
Tensile strength of ABS/PA6 composites reinforced with HNO<sub>3</sub>-treated carbon fibers.
- Published in:
- Mechanics of Composite Materials, 2009, v. 45, n. 5, p. 537, doi. 10.1007/s11029-009-9101-x
- By:
- Publication type:
- Article
In the article “Alteration of the Mechanical Behaviour of Polypropylene Owing to Successive Introduction of Multiwall Carbon Nanotubes and Stretching” by D. T. G. Katerelos, R. Joffe, D. Labou, and L. Wallstrom, Vol. 45, No. 4, 423-434 (2009), the following should be noted:
- Published in:
- 2009
- By:
- Publication type:
- Correction Notice