Works matching IS 19322135 AND DT 2022 AND VI 17 AND IP 5
Results: 26
Local silica sand as a silica source in the synthesis of Y zeolite.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2824
- By:
- Publication type:
- Article
Scrutiny of physico‐chemical properties of extractant‐diluent phase: Keystone of extraction systems.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2823
- By:
- Publication type:
- Article
Optimization of annular distributor for industrial riser reactor with weakened catalyst attrition.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2822
- By:
- Publication type:
- Article
Differences of the pyrolytic behaviors and pyrolysis products of coal pitch from different sources.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2821
- By:
- Publication type:
- Article
Synthesis of low‐costing 4A‐zeolite and stabilization of heavy metals from municipal solid waste incineration fly ash and activated red mud.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2820
- By:
- Publication type:
- Article
Pervaporative desalination of high salinity water using chitosan‐based thin film composite membranes.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2819
- By:
- Publication type:
- Article
Determination of mean activity coefficients and prediction of phase equilibria of the NaCl‐SrCl<sub>2</sub>‐H<sub>2</sub>O solution at 318.15 K.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2818
- By:
- Publication type:
- Article
CO<sub>2</sub> removal in humid environment by ion‐exchange membranes.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2816
- By:
- Publication type:
- Article
User‐friendly point of care test device for detection of arsenic in potable water: Prototype, design, and artifact.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2815
- By:
- Publication type:
- Article
Multi‐objective optimization and dynamic control of heat exchanger network for heat pump distillation of acetic acid/acetic anhydride binary system.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2814
- By:
- Publication type:
- Article
Experimental study on seepage flow characteristics of leaked molten salt in foundation fillers in concentrating solar power plants.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2813
- By:
- Publication type:
- Article
Staged co‐gasification characteristics of pyrolyzed semi‐coke and antibiotic filter residue under oxy‐fuel condition.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2812
- By:
- Publication type:
- Article
A novel process for the synthesis of p‐aminophenol by transfer hydrogenation of nitrobenzene using formic acid as hydrogen source.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2806
- By:
- Publication type:
- Article
Research on the measurement method of fuel feeding temperature during circulating fluidized bed boiler's start‐up.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2810
- By:
- Publication type:
- Article
Evaluation of roll dry granulation process on the high‐viscosity melt solidification and heat recovery.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2809
- By:
- Publication type:
- Article
An investigation on scaling failure of heat exchanger in cooling water system of natural gas purification plant.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2808
- By:
- Publication type:
- Article
Experimental research on fully burning high‐alkali coal in a 300 MW boiler with slag‐tap furnace.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2807
- By:
- Publication type:
- Article
Iterative quality weighted interpolation for LPV‐MPC control of industrial heat exchanger under varying fouling conditions.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2811
- By:
- Publication type:
- Article
Digitalized turbulent behaviors of air and rice husk flow in a vertical suspension furnace from computational fluid dynamics simulation.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2805
- By:
- Publication type:
- Article
Catalytic oxidative dehydrogenation of ethane using carbon dioxide as a soft oxidant over Co‐HMS catalysts to ethylene.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2804
- By:
- Publication type:
- Article
Flow and heat transfer characteristics of a fractal microchannel heat sink with three‐dimensional fractal tail.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2803
- By:
- Publication type:
- Article
Optimization of formation of phase pure hydroxyapatite and fabrication of electrochemically stable HAP coatings on 316L SS for orthopedic applications.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2801
- By:
- Publication type:
- Article
Investigation of the drag reduction of hydrolyzed polyacrylamide–xanthan gum composite solution in turbulent flow.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2791
- By:
- Publication type:
- Article
Effect of chemical desulfurization on coal properties and sulfur structure based on microwave technology.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2790
- By:
- Publication type:
- Article
The wetting process and crystallisation of Al<sub>2</sub>O<sub>3</sub> substrate with molten slags: Addition of CaO‐Fe<sub>2</sub>O<sub>3</sub>.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2788
- By:
- Publication type:
- Article
Issue Information.
- Published in:
- Asia-Pacific Journal of Chemical Engineering, 2022, v. 17, n. 5, p. 1, doi. 10.1002/apj.2661
- Publication type:
- Article