We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Microstructure and Low-Cycle Fatigue of a Friction-Stir-Welded 6061 Aluminum Alloy.
- Authors
Feng, A. H.; Chen, D. L.; Ma, Z. Y.
- Abstract
Strain-controlled low-cycle fatigue (LCF) tests and microstructural evaluation were performed on a friction-stir-welded 6061Al-T651 alloy with varying welding parameters. Friction stir welding (FSW) resulted in fine recrystallized grains with uniformly distributed dispersoids and dissolution of primary strengthening precipitates β″ in the nugget zone (NZ). Two low-hardness zones (LHZs) appeared in the heat-affected zone (HAZ) adjacent to the border between the thermomechanically-affected zone (TMAZ) and HAZ, with the width decreasing with increasing welding speed. No obvious effect of the rotational rate on the LHZs was observed. Cyclic hardening of the friction-stir-welded joints was appreciably stronger than that of base metal (BM), and it also exhibited a two-stage character where cyclic hardening of the friction-stir-welded 6061Al-T651 alloy at higher strain amplitudes was initially stronger followed by an almost linear increase of cyclic stress amplitudes on the semilog scale. Fatigue life, cyclic yield strength, cyclic strain hardening exponent, and cyclic strength coefficient all increased with increasing welding speed, but were nearly independent of the rotational rate. Most friction-stir-welded joints failed along the LHZs and exhibited a shear fracture mode. Fatigue crack initiation was observed to occur from the specimen surface, and crack propagation was mainly characterized by the characteristic fatigue striations. Some distinctive tiremark patterns arising from the interaction between the hard dispersoids/inclusions and the relatively soft matrix in the LHZ under cyclic loading were observed to be present in-between the fatigue striations.
- Subjects
COLD working of metals; ALUMINUM alloys; IRONWORK; SOLDER &; soldering; COLLOIDS
- Publication
Metallurgical & Materials Transactions. Part A, 2010, Vol 41, Issue 10, p2626
- ISSN
1073-5623
- Publication type
Article
- DOI
10.1007/s11661-010-0279-2