We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Microstructural Characteristics and Mechanical Properties of Repaired Titanium Alloy Blade by Arc Additive Manufacturing Process.
- Authors
Liu, Yibo; Jin, Peng; Li, Junzhao; Lin, Tong; Li, Fuxiang; Hou, Shaojun; Sun, Qingjie; Feng, Jicai
- Abstract
To improve repair efficiency and achieve a high‐quality repair layer, wire and arc additive manufacturing process is used in this study to repair missing‐angle Ti‐6Al‐4V blade. The deposition layer with a mixed equiaxed β and columnar grain can be obtained by optimizing the deposition speed and single layer height. According to the characteristics of β grain, the typically repaired thin‐walled part is divided into four representative areas, including heat affected zone (HAZ), bottom layer, middle layer, and top layer. The bottom layer consists of coarsely near‐equiaxed β grains with martensite α′ and basket‐weave structure, and the columnar β grains grow perpendicularly from middle layer to top layer. The heat accumulation in HAZ continues to increase which resulted in a certain degree of cooling rate reduction, resulting in the martensite α′ decomposed to α dots and rods in HAZ near the layer band. The fine near‐equiaxed β grains (78 ± 28 μm), martensite α′ structure, and fine lamellar α structure are presented in HAZ, causing the fracture transition from the HAZ to bottom region. The characteristic of ductile rupture is observed in repaired thin‐wall, the maximum tensile strength is 991 MPa, and the elongation reaches about 10%.
- Subjects
MANUFACTURING processes; TITANIUM alloys; GRAIN farming; SPARE parts; MIXING height (Atmospheric chemistry); TENSILE strength
- Publication
Advanced Engineering Materials, 2020, Vol 22, Issue 11, p1
- ISSN
1438-1656
- Publication type
Article
- DOI
10.1002/adem.202000187