We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
PROPERTIES OF HIGH-ALLOYED METAL DEPOSITED USING ELECTROSLAG TWO-STRIP METHOD.
- Authors
Babinets, A. A.
- Abstract
During surfacing of corrosion-resistant layer on the parts of power and chemical equipment it is often necessary to obtain a specified chemical composition and properties of deposited metal already in the first layer. The influence of current, voltage and deposition rate as well as the sizes of gap between the strips on the stability of electroslag process, geometric dimensions of deposited beads and volume of base metal in the deposited metal were investigated. The range of surfacing modes using two strips of stainless steel of 0.5×60 mm section was determined, in which a stable electroslag process with a good formation of deposited metal and minimum penetration of the base metal in the range of 7-9 %, i.e. Is = 1400-1500 A, Us = 32-33 V and vd = 14-17 m/h; 16 mm gap between the strips, is observed. The mechanical properties of metal, deposited at these modes using strips ESAB OK Band 309LNb ESW and Sv-08Kh19N10G2B under flux ESAB OK 10.10, are at a sufficiently high level and meet the requirements specified to them. The obtained results may be used in selection or development of materials and technologies of anticorrosive surfacing of parts of power and chemical equipment. 11 Ref., 4 Tables, 5 Figures.
- Subjects
ALLOYS; CORROSION resistant materials; ELECTROSLAG process; ELECTRODE efficiency
- Publication
Paton Welding Journal, 2016, Issue 4, p39
- ISSN
0957-798X
- Publication type
Article
- DOI
10.15407/tpwj2016.04.04