We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Solder Flux Residues and Humidity-Related Failures in Electronics: Relative Effects of Weak Organic Acids Used in No-Clean Flux Systems.
- Authors
Verdingovas, Vadimas; Jellesen, Morten; Ambat, Rajan
- Abstract
This paper presents the results of humidity testing of weak organic acids (WOAs), namely adipic, succinic, glutaric, dl-malic, and palmitic acids, which are commonly used as activators in no-clean solder fluxes. The study was performed under humidity conditions varying from 60% relative humidity (RH) to ∼99%RH at 25°C. The following parameters were used for characterization of WOAs: mass gain due to water adsorption and deliquescence of the WOA (by quartz crystal microbalance), resistivity of the water layer formed on the printed circuit board (by impedance spectroscopy), and leakage current measured using the surface insulation resistance pattern in the potential range from 0 V to 10 V. The combined results indicate the importance of the WOA chemical structure for the water adsorption and therefore conductive water layer formation on the printed circuit board assembly (PCBA). A substantial increase of leakage currents and probability of electrochemical migration was observed at humidity levels above the RH corresponding to the deliquescence point of WOAs present as contaminants on the printed circuit boards. The results suggest that use of solder fluxes with WOAs having higher deliquescence point could improve the reliability of electronics operating under circumstances in which exposure to high humidity is likely to occur.
- Subjects
HUMIDITY research; SOLDER &; soldering; STRAY currents; IMPEDANCE spectroscopy; PRINTED circuits industry
- Publication
Journal of Electronic Materials, 2015, Vol 44, Issue 4, p1116
- ISSN
0361-5235
- Publication type
Article
- DOI
10.1007/s11664-014-3609-0