We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Heat-assisted μ-electrical discharge machining of silicon.
- Authors
Daud, Noor Dzulaikha; Mohd Ghazali, Farah Afiqa; Abd Hamid, Fatimah Khairiah; Nafea, Marwan; Saleh, Tanveer; Leow, Pei Ling; Mohamed Ali, Mohamed Sultan
- Abstract
Micro-electrical discharge machining (μEDM) is an unconventional machining method that is suitable for machining of conductive materials including highly doped silicon (Si) wafers. This paper reports a novel method of heat-assisted μEDM machining of Si wafers by varying the temperature to increase the electrical conductivity of Si. In order to achieve this condition, a ceramic heater is used to heat the Si wafers within the temperature range of 30–250 °C. In this study, the machining performances in terms of the material removal rate, tool wear rate, surface quality, and materials characterization have been investigated accordingly. The machining performance of p-type (1–10 Ω cm) Si wafers was investigated to machine a cavity based on different temperatures with a constant discharge energy of 50 μJ and a feed rate of 50 μm/min. The results indicated that increasing the machining temperature allowed achieving a higher material removal rate, lower tool wear rate, and lower surface roughness. The highest material removal rate of 1.43 × 10−5 mm3/s and a surface roughness of 1.487 μm were achieved at 250 °C. In addition, the material removal rate increased by a factor of ~16 times compared to the results obtained at the lowest temperature, 30 °C, and the Raman spectroscopy analysis revealed that no significant changes occurred in the Si structure before and after machining.
- Publication
International Journal of Advanced Manufacturing Technology, 2021, Vol 113, Issue 5/6, p1727
- ISSN
0268-3768
- Publication type
Article
- DOI
10.1007/s00170-021-06734-y