We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Effect of curing method and thermocycling on flexural strength and microhardness of a new composite resin with alkaline filler.
- Authors
Bahari, Mahmoud; Kahnamoui, Mehdi Abed; Ebrahimi Chaharom, Mohammad Esmaeel; Kimyai, Soodabeh; Sattari, Zeinab
- Abstract
Background: Cention N has been introduced as an alternative material for amalgam. The purpose was to investigate the flexural strength and microhardness of this material in self-cure and dual-cure modes before and after thermocycling. Materials and Methods: In this experimental study, 40 samples of Cention N were prepared in order to determine and compare the microhardness. Half of the samples were set by self-cure method and the other half with dual-cure method. The Vickers microhardness test was performed once after 24 h and again after 10000 thermocyclings. Three-point flexural test was used to determine and compare the flexural strength of 52 rod-shaped samples. Half of the samples were set by self-cure method and the other half with dual-cure method. Among 26 samples in each group, 13 samples were randomly selected and three-point flexural test was performed after 24 h and for another 13 samples after 10,000 thermocyclings. Data were analyzed using two-way ANOVA and paired samples t-test (P < 0.05). Results: There was a statistically significant difference between the mean of microhardness values in two curing methods (P < 0.001) and in two storage conditions (P < 0.001). The mean of dual-cure microhardness (100.99 ± 7.22) was higher than that of self-cure (64.61 ± 12.51) and the mean value associated with pre-thermocycling (89.75 ± 15.84) was higher than that of the post-thermocycling (76.44 ± 23.56). There was no statistically significant difference between the mean flexural strength in the two curing methods (self-cure [72.85 ± 16.26], dual cure [79.87 ± 23.07]; [P > 0.05]). However, the mean flexural strength without thermocycling (85.98 ± 21.74) was higher than that of the thermocycled group (64.24 ± 6.40) (P < 0.001). Conclusion: The microhardness of Cention N in dual-cure mode was higher than that of self-cure mode, but the flexural strength of dual-cure was not significantly different from that of self-cure. Thermocycling had a significant effect on the microhardness and flexural strength.
- Subjects
DENTAL bonding; EXPERIMENTAL design; DENTAL resins; ANALYSIS of variance; DENTAL materials; T-test (Statistics); TENSILE strength; DESCRIPTIVE statistics; DENTAL fillings
- Publication
Dental Research Journal, 2021, Vol 18, Issue 10, p1
- ISSN
1735-3327
- Publication type
Article