We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Preparation of TiC reinforced CrMo steel by 3D gel-printing.
- Authors
Lin, Tao; Li, Qianghua; Song, Ke; Shao, Huiping; Yuan, Jiayun; Deng, Xin
- Abstract
TiC-reinforced CrMo steel was successfully fabricated by 3D gel-printing in this study. The rheological behaviour and polymerisation of slurries with different TiC content were researched. The appropriate parameters of 3D gel-printing process were found. The microstructure and phase identification of sintered samples were characterised by using scanning electron microscopy and X-ray diffraction, respectively. The relative density, bending strength and hardness of sintered bulk samples were separately measured. The results indicate that the relative density, bending strength and hardness value reach 99.8%, 2039 MPa and 51.3 HRC when TiC content is 30 wt.% in the sintered bulk samples. After oil quenching, the bending strength reaches an astonishing value 2386 MPa, and hardness is 56.1 HRC. Compared with conventional powder metallurgy methods, the mechanical properties of TiC–CrMo steel composite prepared by 3DGP are similar or even better.
- Subjects
SPECIFIC gravity; STEEL; POWDER metallurgy; SLURRY; SCANNING electron microscopy; X-ray microscopy; BENDING strength
- Publication
Powder Metallurgy, 2021, Vol 64, Issue 5, p360
- ISSN
0032-5899
- Publication type
Article
- DOI
10.1080/00325899.2021.1911068