We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
In-situ Liquid Storage Capacity Measurement of Subsurface Wastewater Absorption System Products.
- Authors
Quisenberry, Virgil; Brown, Philip; Smith, Bill
- Abstract
A method is presented for measuring the in-situ liquid storage capacity of subsurface wastewater infiltration system (SWIS) products. While these products vary in composition, geometry, and porosity, they all have the same function: to provide a conduit for the (low of effluent from a septic tank to and through a trench so that infiltration into the soil can occur. A functional SWIS must also provide temporary liquid storage. Storage is necessary for periods when discharge from the septic tank exceeds the infiltration rate of the soil. Storage is also important during times when the soil in and around the trench is saturated. Many states now have regulatory requirements pertaining to storage volume, and these requirements commonly establish the traditional gravel-pipe system as the standard for minimally acceptable volume. Reliable comparisons between various alternative products and gravel have been difficult or impossible, because there has been no standard method for measuring storage volume. Some products have been evaluated under realistic field conditions; others have been evaluated under theoretical or ideal conditions. The protocol developed by the study reported here can serve as a common, accurate basis for comparisons. A 3-foot-deep trench was excavated, and the bottom was leveled. Markers (nails or rods) were attached to the products to indicate the invert and full-volume heights. The products were then enclosed in plastic, placed in a trench, and covered with soil. A 4-inch-diameter pipe extended from the product to the surface to allow metered additions of water into the products and precise determinations when the systems had been filled to capacity. Four plastic chambers, three expanded polystyrene (ESP) products, two multipipe arrangements, and a standard gravel-pipe system were evaluated. The standard gravel-pipe system held 10.2 gal/ft. Three of the four plastic chambers stored from 100 to 130 percent of what the standard system held. The multipipe systems held 80 and 90 percent of the standard. The ESP bundles held less than 75 percent of the standard, with the most commonly used configuration storing about 60 percent. The rigid products were found to store amounts that agreed with their companies' reported values, The ESP products retained less than company reported values. These differences illustrate the need for a standard protocol for measuring storage volume.
- Subjects
SEWAGE disposal; WASTEWATER treatment; WATER seepage; SEPTIC tanks; POROSITY; STORAGE; SOIL infiltration; PUBLIC health laws; TRENCHES
- Publication
Journal of Environmental Health, 2006, Vol 69, Issue 4, p9
- ISSN
0022-0892
- Publication type
Article