We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Optical design of a near-infrared imaging spectropolarimeter for the Advanced Technology Solar Telescope.
- Authors
Greco, Vincenzo; Cavallini, Fabio
- Abstract
In designing the optics of an imaging multi-etalon spectro polarimeter as a post-focus instrument for the Advanced Technology Solar Telescope (ATST), many constraints must be considered. Among these are the large entrance pupil diameter of the telescope (4 m), the demanded large field of view (≥90 arc sec), high spectral resolving power (≥200,000), and limited field-dependent blue-shift of the instrumental profile [≤3 full width at half maximum (FWHM)], which require Fabry-Perot interferometers of large diameter (≥200 mm), lighted by highly collimated beams. This implies large optical elements and long optical paths. Moreover, to use interference pre-filters with a relatively small diameter (≤70 mm) and placed between the interferometers to reduce the inter-reflections in axial-mount, a "pupil adapter" must be included with a further increase of the optical path length. Although a multi-etalon spectropolarimeter works in quasi-monochromatic light, the Fraunhofer lines of interest cover a wide range of wavelengths (850 to 1650 nm), which demands a good chromatic aberration control. A low instrumental polarization (≤0.5%) is also required to allow a high polarimetric precision. Finally, some secondary optical paths are required to perform the initial instrumental setup and to secure the best instrumental performances. A diffraction-limited optical solution for ATST is described that fulfills all the above requirements in a relative small volume.
- Subjects
INFRARED imaging; OPTICAL engineering; SOLAR telescopes; INTERFEROMETERS; SPECTROPOLARIMETERS; ACHROMATISM; FRAUNHOFER lines
- Publication
Optical Engineering, 2013, Vol 52, Issue 6, p1
- ISSN
0091-3286
- Publication type
Article
- DOI
10.1117/1.OE.52.6.063001