We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
Analyse von 3D-CT-Aufnahmen von Spänen zur Extrahierung der Segmentspanbildungsfrequenz.
- Authors
Schwär, Daniel; Kunz, Andreas; Dehen, Stephan; Zanger, Frederik; León, Fernando Puente
- Abstract
Die Vermessung von Spänen, welche bei einem Drehprozess entstehen, ist insbesondere bei einer helixartigen Form eine große Herausforderung. Die Analyse lässt sich nur in den Randbereichen durchführen, da die inneren Bereiche durch den Span selbst verdeckt werden. Außerdem lassen sich Späne, die aus sprödem Material bestehen, nicht zerstörungsfrei analysieren. Da sich metallisches Material sehr genau durch einen Computertomographen vermessen lässt, wurde eine Methode entwickelt, mit welcher sich das 3D-Bild eines Spanes virtuell zu einem geradlinigen Span transformieren lässt. Im Anschluss liegt der Fokus auf der Extrahierung des Segmentspanabstandes, welcher über einen Stauchungsfaktor mit der Segmentspanbildungsfrequenz zusammenhängt. Zuletzt wird die Methode mit einer manuellen Untersuchung der Späne unter einem konfokalen Mikroskop verglichen, wobei gezeigt werden kann, dass der Vorteil der CT-Analyse darin liegt, dass sie auch in der Analyse helixförmiger Späne zu einem Ergebnis kommt. The analysis of chips produced during a turning process is a difficult challenge, especially with a curled shape. The examination can often only be performed in the peripheral areas, as the inner areas are covered by the chip itself. Chips that consist of brittle material often cannot be analyzed non-destructively. Since metallic material can be measured very accurately by a computer tomograph, a method was developed which makes it possible to transform the 3D image of a chip virtually into a straight chip. After this, the focus is on the extraction of the chip segment length, which is related to the segment frequency by a compression factor. Finally, the method is compared with a manual examination of the chips under a confocal microscope. It can be shown that the CT-analysis comes to a result in the analysis of curled chips.
- Subjects
BRITTLE materials; THREE-dimensional imaging; MICROSCOPES; MATERIALS; TOMOGRAPHY
- Publication
Technisches Messen, 2020, Vol 87, ps22
- ISSN
0171-8096
- Publication type
Article
- DOI
10.1515/teme-2020-0039