We found a match
Your institution may have access to this item. Find your institution then sign in to continue.
- Title
FORMATION OF A JOINT BETWEEN DEPOSITED AND BASE METALS DURING LASER CLADDING OF A NICKEL-BASED POWDER ONTO A COPPER-BASED ALLOY.
- Authors
Bourahima, F.; Baudin, T.; Rege, M.; Ji, V.; Brisset, F.; Zavdoveev, A.; Helbert, A. L.
- Abstract
Laser cladding is an alternative method to other cladding techniques such as Plasma Transfer Arc (PTA) or blowtorch for surface treatment in the glass industry. It aims to produce dense, high-quality coatings on a non-planar surface without affecting its thermal and mechanical properties. In this study, Ni-based coatings were coated onto Cu-Ni-Al substrate using a 3 JET nozzle technique. During laser cladding, good metallurgical bonding is necessary to ensure the further surfacing process technique. A microstructural analysis was conducted, and the mechanical properties were then evaluated with microhardness analysis to link process parameters to coating bonding quality. A calculation of the power attenuation attempts to explain the impact of the powder distribution on the bonding. This work revealed that a chemical dilution zone exists between coating and substrate and is necessary for perfect metallurgical bonding. The heterogeneous bonding, observed through the section, along the curved interface coating/substrate, has been linked to the Gaussian distribution of the powder that attenuates the input power. The attenuated power was measured all along the interface. 35 Ref., 2 Tabl., 10 Fig. Лазерне наплавлення є альтернативним методом наплавлення до таких, як плазмово-дугове або паяння. Воно спрямовано на отримання щільних високоякісних наплавлень на неплоских поверхнях без впливу на їх механічні властивості. У цьому дослідженні наплавлення матеріалу на основі Ni були нанесені на підкладку Cu-Ni-Al за допомогою 3-струменевого сопла. Під час лазерного наплавлення необхідне хороше металургійне зчеплення для забезпечення подальшої техніки процесу наплавлення. Було проведено мікроструктурний аналіз, а також оцінено механічні властивості за допомогою аналізу мікротвердості, щоб зв’язати параметри процесу з якістю зчеплення покриття. Розрахунок ослаблення потужності дає змогу пояснити вплив розподілу порошку на зчеплення. Ця робота показала, що між наплавленням і підкладкою існує зона хімічного розчинення, яка необхідна для ідеального металургійного з’єднання. Гетерогенне зчеплення, що спостерігається через ділянку, вздовж вигнутої поверхні розділу покриття/підкладка, пов’язане з Гауссовим розподілом порошку, який послаблює вхідну потужність. Ослаблену потужність вимірювали по всьому інтерфейсу. Бібліогр.
- Subjects
SURFACE preparation; JET nozzles; POWDERS; LASERS; GAUSSIAN distribution; ALLOY powders
- Publication
Automatic Welding / Avtomatitcheskaia Svarka, 2022, Issue 4, p26
- ISSN
0005-111X
- Publication type
Article